why is my Volvo XC90 making a clicking noise when turning

Volvo XC90 Second Generation (2015-2024)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

520 words

Problem Statement

Learn how to diagnose and fix the clicking noise when turning in your Volvo XC90. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always disconnect the battery when working on electrical systems.
•Allow the vehicle to cool before working on hot components.

Symptoms

•Clicking noise when turning the steering wheel
•Noise may increase with speed
•Vibration in the steering wheel
•Possible loss of power steering assistance
•Uneven tire wear may be observed

Diagnostic Steps

1
Inspect the CV joints for wear or damage.
2
Check the wheel bearings for play or noise.
3
Examine the suspension components for any loose or damaged parts.
4
Test drive the vehicle to replicate the noise and identify specific turning conditions.
5
Inspect the power steering fluid level and condition.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Jack
•Jack stands
•Socket set
•Torque wrench
•Pry bar
•Bearing puller
•Wrench set
•Flashlight

Parts Required

•CV joint or axle assembly (if necessary)
•Wheel bearings (if necessary)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather tools and parts needed for the repair.
Park the vehicle on a flat surface and engage the parking brake.
Wear safety gloves and goggles.

2. Inspect and Replace CV Joints

Tools Required: Jack, jack stands, socket set, torque wrench, pry bar.
Sub-steps:
1. Raise the front of the vehicle using a jack and support it with jack stands.
2. Remove the front wheels using a socket set.
3. Inspect the CV joints for torn boots or excessive play.
4. If damaged, remove the axle nut and detach the CV joint from the hub using a pry bar.
5. Replace the CV joint or axle assembly as necessary, ensuring that the new part is properly lubricated.
6. Reinstall the axle nut to the manufacturer's specified torque value (typically around 180-250 Nm).
7. Reattach the wheel and lower the vehicle.

3. Inspect and Replace Wheel Bearings

Tools Required: Bearing puller, socket set, torque wrench.
Sub-steps:
1. With the vehicle raised and front wheels removed, inspect the wheel bearings for noise and play.
2. If the bearings are faulty, use a bearing puller to remove the old bearings.
3. Install new wheel bearings, ensuring they are properly seated.
4. Torque the bearing nut to the specified value (usually around 30-50 Nm).
5. Reinstall the wheel and lower the vehicle.

4. Check Suspension Components

Tools Required: Wrench set, flashlight.
Sub-steps:
1. Inspect all suspension components (control arms, bushings, struts).
2. Tighten any loose bolts or replace damaged parts.
3. Ensure all connections are secure.