how to reset maintenance light in Volvo XC60 536 (2017-Present)

Volvo XC60 536 (2017-Present)

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

334 words

Problem Statement

Step-by-step guide to reset the maintenance light on a 2017-Present Volvo XC60. Quick and easy instructions for a successful reset.

Affected Component

Electrical

Estimated Time

5-10 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in park and on a flat surface before performing the reset.

1
Ensure the vehicle is in the 'OFF' position and the key is removed from the ignition.
2
Insert the key into the ignition without turning it to start the engine.
3
Press and hold the 'OK' button on the steering wheel.
4
While holding the 'OK' button, turn the ignition to the 'ON' position (do not start the engine).
5
Continue holding the 'OK' button until the maintenance light resets.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position and the key is removed from the ignition.
2
Insert the key into the ignition without turning it to start the engine.
3
Press and hold the 'OK' button on the steering wheel.
4
While holding the 'OK' button, turn the ignition to the 'ON' position (do not start the engine).
5
Continue holding the 'OK' button until the maintenance light resets.

Solution

1. Preparation

Gather necessary tools such as the ignition key and ensure you are in a well-lit area to see the dashboard clearly.

2. Resetting the Maintenance Light

Insert Key: Place the key in the ignition slot without turning it.
Press and Hold "OK": Hold down the "OK" button located on the steering wheel.
Turn to "On" Position: While holding the "OK" button, turn the ignition to the "ON" position without starting the engine.
Wait for Reset: Maintain pressure on the "OK" button until the maintenance light turns off or the reset message appears on the display.
Release "OK" Button: Once you see the confirmation that the maintenance light has been reset, release the "OK" button and turn the ignition off.