why does my Volvo XC60 Second Generation (2018-2024) have a noise when turning?

Volvo XC60 Second Generation (2018-2024)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

506 words

Problem Statement

Learn how to diagnose and fix noise when turning in Volvo XC60. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Steering

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on any electrical components.
•Allow the vehicle to cool down before inspecting the suspension or steering systems.

Symptoms

•Grinding or squeaking noise when turning the steering wheel
•Clunking sound over bumps while turning
•Steering wheel vibration during turns
•Difficulty in steering, or feeling of looseness
•Increased tire wear on the outer edges

Diagnostic Steps

1
Inspect the power steering fluid levels and condition.
2
Check for leaks in the power steering system.
3
Examine the tie rod ends and ball joints for wear or damage.
4
Inspect the CV joints for any signs of wear or tearing.
5
Test the steering rack for any unusual play or noise.
6
Look over the suspension components for damage or looseness.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Socket set
•Torque wrench
•Pry bar
•CV joint grease
•Jack and jack stands
•Fluid catch pan

Parts Required

•Power steering fluid
•Tie rod ends (if needed)
•Ball joints (if needed)
•CV joint (if needed)
•Suspension components (if needed)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the power steering fluid levels and condition.
2
Check for leaks in the power steering system.
3
Examine the tie rod ends and ball joints for wear or damage.
4
Inspect the CV joints for any signs of wear or tearing.
5
Test the steering rack for any unusual play or noise.
6
Look over the suspension components for damage or looseness.

Solution

1. Preparation

Gather tools and parts required.
Ensure the vehicle is on a level surface and secure it with wheel chocks.
Wear safety glasses and gloves.

2. Inspect Power Steering System

Tools Required: Socket set, fluid catch pan
Check the power steering fluid level; if low, fill to the manufacturer's recommended level with the correct type of fluid.
Inspect for any visible leaks around the power steering pump and hoses.

3. Check Steering Components

Tools Required: Torque wrench, pry bar
Inspect tie rod ends and ball joints using a pry bar to check for play. Replace any worn components.
Torque tie rod nuts to the manufacturer’s specifications (typically around 50-70 lb-ft, verify with specific service manual).

4. Examine CV Joints

Tools Required: CV joint grease, boot clamps
Inspect the CV joints for cracks or tears in the boots. If damage is found, replace the CV joint.
Apply new grease and secure with fresh boot clamps.

5. Inspect Suspension Components

Tools Required: Jack and jack stands
Raise the vehicle and check the suspension components (shocks, struts, control arms) for damage or excessive wear.
Replace any damaged or worn parts according to manufacturer specifications.