why does my Volkswagen Tiguan make a clicking sound when turning left

Volkswagen Tiguan Second Generation (2018-present)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

478 words

Problem Statement

Learn how to diagnose and fix the clicking sound when turning left in your Volkswagen Tiguan. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems.
•Ensure the vehicle is securely lifted and supported before working underneath.

Symptoms

•Clicking or popping noise when turning left
•Noise intensity increases with speed
•Vibration felt in the steering wheel
•Difficulty in steering or a feeling of looseness
•Potential loss of traction during turns

Diagnostic Steps

1
Inspect the front CV joints for wear or damage.
2
Check the wheel bearings for play or noise.
3
Examine the suspension components, including control arms and bushings.
4
Raise the vehicle and spin the front wheels to listen for abnormal noises.
5
Verify proper torque on wheel lug nuts.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Socket set
•Torque wrench
•Bearing puller
•Jack and jack stands

Parts Required

•CV joint or axle (if damaged)
•Wheel bearings (if needed)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Ensure the vehicle is parked on a level surface.
Gather tools and parts required for the repair.
Disconnect the negative battery terminal to prevent electrical issues.

2. Inspect and Replace CV Joint

Inspect CV Joint:
- Remove the wheel covering the affected side.
- Dismount the wheel using a socket set.
- Inspect the CV boot for tears or grease leakage.
Remove CV Axle:
- Remove the axle nut using a torque wrench (typically around 30-50 ft-lbs).
- Disconnect the lower ball joint if necessary.
- Pull the CV axle out from the wheel hub.
Install New CV Joint:
- Insert the new CV axle into the hub and secure it with the axle nut.
- Reattach the ball joint if disconnected.
- Reinstall the wheel and torque the lug nuts to the manufacturer’s specifications (usually around 75-90 ft-lbs).

3. Check Wheel Bearings

Inspect Bearings:
- Spin the wheel to listen for grinding noises.
- Check for any play in the wheel by shaking it up and down.
Replace Bearings (if necessary):
- Remove the wheel and brake caliper.
- Use a bearing puller to remove the old wheel bearing.
- Install the new bearing using a press or hammer gently, ensuring it sits flush.
- Reassemble the wheel and caliper.