why does my Volkswagen Tiguan make a clicking noise when turning

Volkswagen Tiguan Second Generation (2018-present)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

472 words

Problem Statement

Learn how to diagnose and fix clicking noise when turning in Volkswagen Tiguan. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems.
•Allow the vehicle to cool before inspecting the brakes or suspension components.

Symptoms

•Clicking or popping noise during left or right turns
•Noise increases or decreases with vehicle speed
•Vibration felt in the steering wheel
•Difficulty in steering or feeling of looseness
•Possible clunking noise when going over bumps

Diagnostic Steps

1
Inspect the front CV joints for wear or damage.
2
Check the wheel bearings for play or noise.
3
Examine suspension components, including control arms and bushings.
4
Test the power steering fluid level and condition.
5
Scan for any trouble codes that might indicate a related issue.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Jack and jack stands
•Socket set
•Torque wrench
•Bearing puller
•Wrench set

Parts Required

•CV joint or axle assembly
•Wheel bearing
•Suspension bushings (if worn)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather necessary tools and parts.
Ensure the vehicle is on a level surface.
Disconnect the battery for safety (if applicable).

2. Inspect and Replace CV Joints

Tools Required: Jack and jack stands, socket set, torque wrench.
Sub-steps:
1. Lift the front of the vehicle using a jack and secure it with jack stands.
2. Remove the wheel on the side where the noise is occurring.
3. Inspect the CV joint boots for tears or leaking grease.
4. If the boot is damaged, remove the CV axle using the socket set.
5. Replace the CV joint or axle assembly if it shows signs of wear.

3. Check and Replace Wheel Bearings

Tools Required: Bearing puller, socket set.
Sub-steps:
1. Rotate the wheel and listen for any grinding or roughness, indicating a bad bearing.
2. If necessary, remove the brake caliper and rotor to access the wheel bearing.
3. Use a bearing puller to remove the old bearing.
4. Install the new wheel bearing and reassemble the brake components.

4. Inspect Suspension Components

Tools Required: Wrench set, torque wrench.
Sub-steps:
1. Visually inspect control arms, bushings, and struts for wear or damage.
2. Tighten any loose bolts as per manufacturer specifications.
3. Replace any worn or damaged suspension components as needed.