why does my Volkswagen Tiguan Second Generation (2018-present) key fob not work sometimes

Volkswagen Tiguan 2nd Gen (2018-Present)

Error Codes

30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

466 words

Problem Statement

Learn how to diagnose and fix intermittent key fob issues in Volkswagen Tiguan Second Generation. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Electrical

Estimated Time

30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Handle the key fob components carefully to avoid damaging the electronic circuitry.

Symptoms

•Key fob does not respond when buttons are pressed.
•Vehicle fails to unlock or lock with the fob.
•Check engine light or other warning lights may illuminate sporadically.
•Battery drain occurs when the fob is not in use.
•Physical key inside the fob is difficult to extract.

Diagnostic Steps

1
Inspect the key fob battery for signs of corrosion or low charge.
2
Test the key fob range by attempting to unlock the vehicle from different distances.
3
Use a multimeter to measure the voltage of the key fob battery.
4
Check for any error codes related to key fob or vehicle immobilizer using an OBD-II scanner.
5
Inspect the key fob circuit board for any visible damage or loose components.
6
Verify that the vehicle’s receiver is functioning properly by testing with a spare key fob if available.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Small screwdriver
•Multimeter

Parts Required

•Key fob battery (CR2032)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the key fob battery for signs of corrosion or low charge.
2
Test the key fob range by attempting to unlock the vehicle from different distances.
3
Use a multimeter to measure the voltage of the key fob battery.
4
Check for any error codes related to key fob or vehicle immobilizer using an OBD-II scanner.
5
Inspect the key fob circuit board for any visible damage or loose components.
6
Verify that the vehicle’s receiver is functioning properly by testing with a spare key fob if available.

Solution

1. Preparation

Gather tools: small screwdriver, multimeter, replacement key fob battery (CR2032).
Ensure the vehicle is in a secure location with the engine off.

2. Replace the Key Fob Battery

Open the Key Fob:
- Use a small screwdriver to carefully pry apart the key fob casing.
- Take care not to damage the plastic clips.
Remove the Old Battery:
- Note the orientation of the battery (positive and negative sides).
- Remove the old battery from its compartment.
Install the New Battery:
- Place the new battery (CR2032) into the compartment, ensuring the correct orientation.
- Press down gently to secure the battery in place.

3. Reassemble the Key Fob

Close the Key Fob:
- Align the two halves of the key fob casing.
- Press firmly until the clips snap back into place.
Test the Key Fob:
- Press the buttons to ensure they are working correctly.
- Test the fob on the vehicle to confirm it locks and unlocks as intended.