why does my Volkswagen Golf MK7 (2015-2019) make a popping noise when turning

Volkswagen Golf MK8.5 (2024-Present)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

448 words

Problem Statement

Learn how to diagnose and fix popping noise when turning in Volkswagen Golf MK7 (2015-2019). Step-by-step guide with symptoms, diagnostic steps, and repair instructions.

Affected Component

Suspension

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always disconnect the battery before working on electrical components.
•Allow the engine to cool before performing repairs on hot components.

Symptoms

•Popping noise during turns
•Clunking sound when going over bumps
•Vibration in the steering wheel
•Uneven tire wear
•Steering feels loose or unresponsive

Diagnostic Steps

1
Inspect the front suspension components visually for any signs of wear or damage.
2
Check the CV joints and boots for any tears or leaking grease.
3
Test the steering rack for play or unusual movement.
4
Examine wheel bearings for excessive play or noise.
5
Lift the vehicle and shake the wheel to check for any abnormal movement in suspension parts.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Jack and jack stands
•Socket set
•Torque wrench
•Pry bar
•Safety glasses

Parts Required

•CV joint or axle assembly
•Suspension components (if necessary, e.g., struts, control arms)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the front suspension components visually for any signs of wear or damage.
2
Check the CV joints and boots for any tears or leaking grease.
3
Test the steering rack for play or unusual movement.
4
Examine wheel bearings for excessive play or noise.
5
Lift the vehicle and shake the wheel to check for any abnormal movement in suspension parts.

Solution

1. Preparation

Tools Required: Jack and jack stands, socket set, torque wrench, pry bar, and safety glasses.
Ensure the vehicle is on a flat surface, and engage the parking brake.

2. Inspect and Replace CV Joints

Sub-steps:
1. Raise the front of the vehicle using a jack and secure with jack stands.
2. Remove the front wheels using a socket set.
3. Inspect the CV joints for any signs of damage or excessive play.
4. If damaged, remove the axle by unbolting the CV joint from the hub assembly.
5. Install the new CV joint by reversing the removal steps, ensuring all bolts are torqued to manufacturer specifications (typically around 30-40 Nm).

3. Replace Damaged Suspension Components

Sub-steps:
1. Inspect struts, control arms, and bushings for wear.
2. If any components are worn, remove the necessary parts (such as strut assemblies) by unbolting and using a pry bar if needed.
3. Replace with new components, ensuring all bolts are properly torqued according to manufacturer specifications.
4. Reinstall the wheels and lower the vehicle back to the ground.

4. Test Drive

Conduct a test drive to ensure the popping noise is resolved and the vehicle handles properly.