why is my Volkswagen Golf MK7.5 (2020-Present) shaking when I brake?

Volkswagen Golf MK7.5 (2020-Present)

Error Codes

2-4 hours

Time

medium

Difficulty

high

Severity

3 min read

493 words

⚠️ Safety Warning

This issue requires immediate attention. If you are not experienced with automotive repairs, consult a professional mechanic. Working on critical systems can be dangerous.

Problem Statement

Learn how to diagnose and fix shaking during braking in Volkswagen Golf MK7.5. Step-by-step guide with symptoms, diagnostic steps, and repair instructions.

Affected Component

Brakes

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems.
•Allow the brake components to cool before handling.

Symptoms

•Steering wheel shakes when braking
•Vehicle pulls to one side during braking
•Vibration felt in the brake pedal
•Uneven wear on brake pads or rotors
•Loud grinding or squealing noise during braking

Diagnostic Steps

1
Inspect brake rotors for warping or uneven wear using a runout gauge.
2
Check brake pads for even wear and proper thickness.
3
Examine suspension components (e.g., struts, control arms) for wear or damage.
4
Verify tire balance and alignment.
5
Inspect wheel bearings for play or roughness.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Jack
•Jack stands
•Lug wrench
•Socket set
•Runout gauge

Parts Required

•Brake rotors (if warped)
•Brake pads (if worn)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Ensure the vehicle is parked on a flat surface.
Gather all necessary tools and parts.
Disconnect the battery for safety.

2. Remove Wheel and Brake Components

Tools Required: Jack, jack stands, lug wrench, socket set.
Loosen lug nuts on the affected wheel before lifting the vehicle.
Jack up the vehicle and secure it on jack stands.
Remove the wheel and inspect the brake components.

3. Inspect and Replace Brake Rotors

Check the rotor surface for warping or scoring.
If warping is present, remove the caliper by loosening the caliper bolts.
Slide the caliper off the rotor and support it with a hanger or bungee cord.
Remove the brake rotor by unscrewing any retaining screws and sliding it off the hub.
Install new rotors, ensuring they are clean and free of grease.

4. Inspect and Replace Brake Pads

Check the brake pads for wear; replace if they are below the minimum thickness.
Remove old brake pads from the caliper bracket.
Apply brake grease to the back of the new pads to reduce noise.
Install new brake pads into the caliper bracket.

5. Reassemble and Torque Components

Reinstall the caliper over the new pads and rotor.
Tighten caliper bolts to the manufacturer’s specified torque (usually around 25-35 Nm).
Reattach the wheel and hand-tighten lug nuts before lowering the vehicle.
Lower the vehicle and then torque the lug nuts to the manufacturer's specifications (typically 90-100 Nm).