how to replace the windshield wipers on my Volkswagen Golf MK7.5 (2020-Present)

Volkswagen Golf MK7.5 (2020-Present)

Error Codes

30 minutes

Time

easy

Difficulty

low

Severity

3 min read

470 words

Problem Statement

Step-by-step guide to replacing windshield wipers on Volkswagen Golf MK7.5 (2020-Present). Learn symptoms, diagnostic steps, and installation tips.

Affected Component

Body/Interior

Estimated Time

30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the wiper arms are in the upright position to prevent accidental contact with the windshield.

Symptoms

•Streaking on the windshield during use
•Wipers skipping or jumping across the glass
•Noisy operation while wipers are in motion
•Wipers not making proper contact with the windshield
•Worn rubber blades or visible tears on the wiper blades

Diagnostic Steps

1
Inspect wiper blades visually for cracks, tears, or debris.
2
Test wiper operation to ensure they move freely across the windshield.
3
Check the windshield washer fluid level to rule out any related issues.
4
Verify that the wiper arms are securely attached to the motor shaft.
5
Confirm that the wiper motor is functioning properly by listening for any unusual sounds when activated.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Flathead screwdriver (optional for prying tabs)
•Clean cloth (for cleaning windshield)

Parts Required

•New wiper blades (confirm size: typically 22 inches for driver side and 18 inches for passenger side)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect wiper blades visually for cracks, tears, or debris.
2
Test wiper operation to ensure they move freely across the windshield.
3
Check the windshield washer fluid level to rule out any related issues.
4
Verify that the wiper arms are securely attached to the motor shaft.
5
Confirm that the wiper motor is functioning properly by listening for any unusual sounds when activated.

Solution

1. Preparation

Gather all necessary tools and replacement parts.
Park the vehicle on a flat surface and turn off the engine.
Raise the wiper arms away from the windshield to a vertical position.

2. Remove Old Wiper Blades

Step 1: Locate the small tab on the underside of the wiper blade where it connects to the wiper arm.
Step 2: Press the tab down to release the wiper blade from the arm.
Step 3: Slide the blade off the arm and discard it.

3. Install New Wiper Blades

Step 1: Take the new wiper blade and align the hook on the blade with the wiper arm.
Step 2: Slide the blade onto the arm until it clicks into place, confirming it is secure.
Step 3: Lower the wiper arm back onto the windshield gently to avoid damage.

4. Final Checks

Step 1: Repeat the removal and installation process on the other wiper blade.
Step 2: After both blades are installed, turn on the wipers to ensure they operate smoothly and make proper contact with the windshield.