how to reset EPS (Electric Power Steering) light in Volkswagen Golf MK6 (2009-2014)

Volkswagen Golf MK7 (2015-2019)

Error Codes

1-2 hours

Time

medium

Difficulty

high

Severity

3 min read

450 words

⚠️ Safety Warning

This issue requires immediate attention. If you are not experienced with automotive repairs, consult a professional mechanic. Working on critical systems can be dangerous.

Problem Statement

Learn how to reset the EPS light in your Volkswagen Golf MK6 (2009-2014). Step-by-step guide with diagnostic steps and repair instructions.

Affected Component

Steering

Estimated Time

1-2 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems to prevent shocks or shorts.
•Ensure the vehicle is on a level surface and securely supported before performing any repairs.

Symptoms

•EPS warning light illuminated on the dashboard
•Possible loss of power steering assistance
•Steering wheel may feel heavy or unresponsive
•Warning message displayed on the instrument cluster
•Difficulty in steering, especially at lower speeds

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner to identify any underlying issues.
2
Inspect the power steering fluid level and condition; top off or replace if necessary.
3
Check the electrical connections to the power steering module for corrosion or looseness.
4
Verify the condition of the steering rack and associated components for wear or damage.
5
Perform a visual inspection of the steering column and associated wiring harness for any signs of wear or damage.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Socket set
•Torque wrench
•Screwdrivers

Parts Required

•Power steering fluid (if needed)
•Replacement connectors or components (if identified as faulty)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner to identify any underlying issues.
2
Inspect the power steering fluid level and condition; top off or replace if necessary.
3
Check the electrical connections to the power steering module for corrosion or looseness.
4
Verify the condition of the steering rack and associated components for wear or damage.
5
Perform a visual inspection of the steering column and associated wiring harness for any signs of wear or damage.

Solution

1. Preparation

Gather necessary tools and parts.
Disconnect the vehicle's battery to prevent any electrical shorts.
Allow the vehicle to cool down if recently operated.

2. Address Underlying Issues

If error codes indicate specific faults:
- Repair or replace any faulty components identified during diagnostic steps.
- Ensure that all electrical connections are secure and corrosion-free.

3. Reset EPS Light

Reconnect the battery terminal securely.
Insert the key into the ignition and turn it to the "On" position without starting the engine.
Wait for approximately 10 seconds and then turn the ignition off.
Repeat the process 2-3 times to ensure the system resets properly.
Start the engine and check if the EPS light has turned off.

4. Final Checks

Test drive the vehicle to ensure the power steering operates smoothly.
Monitor the EPS light to verify it remains off during operation.