why is my Volkswagen Golf Eighth Generation (2020-present) making a clicking noise when turning

Volkswagen Golf Eighth Generation (2020-present)

Error Codes

3-5 hours

Time

medium

Difficulty

medium

Severity

3 min read

523 words

Problem Statement

Learn how to diagnose and fix the clicking noise when turning in Volkswagen Golf Eighth Generation. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Steering

Estimated Time

3-5 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems.
•Use jack stands to secure the vehicle when lifted to prevent accidents.

Symptoms

•Clicking noise when turning the steering wheel
•Noise occurs during both left and right turns
•Vibration felt through the steering wheel
•Possible loss of steering response or stiffness
•Unusual wear on tires

Diagnostic Steps

1
Inspect the CV joints for any visible damage or wear.
2
Check the wheel bearings for play or roughness.
3
Examine the power steering fluid level and condition.
4
Test the steering rack and tie rods for any signs of damage.
5
Use a stethoscope to pinpoint the source of the clicking noise while turning.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Jack and jack stands
•Socket set
•Torque wrench
•Bearing puller
•OBD-II scanner

Parts Required

•CV joints or axles
•Wheel bearings
•Power steering fluid

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather all necessary tools and parts.
Park the vehicle on a level surface and engage the parking brake.
Disconnect the battery to ensure safety during repairs.

2. Inspect and Replace CV Joints

Tools Required: Jack and jack stands, socket set, grease, CV joint boot clamps.
Sub-steps:
1. Raise the vehicle using a jack and secure it on jack stands.
2. Remove the front wheels using a socket set.
3. Inspect the CV joints for torn boots or visible wear.
4. If damaged, remove the CV axles by unbolting them from the transmission and hub assembly.
5. Replace with new CV joints or axles and ensure proper greasing.
6. Reinstall the wheels and lower the vehicle.

3. Inspect and Replace Wheel Bearings

Tools Required: Torque wrench, bearing puller, socket set, grease.
Sub-steps:
1. With the vehicle raised, remove the wheel and brake assembly.
2. Inspect the wheel bearing for signs of wear or noise.
3. If necessary, use a bearing puller to remove the old bearing.
4. Install the new wheel bearing and torque it to the manufacturer’s specifications.
5. Reassemble the brake parts and wheel, then lower the vehicle.

4. Check Power Steering System

Tools Required: OBD-II scanner, power steering fluid.
Sub-steps:
1. Check the power steering fluid level and add fluid if low.
2. Scan for any error codes related to the power steering system.
3. If codes are present, follow the manufacturer’s procedures for troubleshooting.
4. Inspect the power steering pump for noise or leaks; replace if necessary.