how to reset the maintenance light on my Toyota RAV4 XA50 (2019-2024)

Toyota RAV4 XA50 (2019-2024)

10 minutes

Time

easy

Difficulty

low

Severity

2 min read

349 words

Problem Statement

Learn how to reset the maintenance light on your 2019-2024 Toyota RAV4 XA50 with this simple step-by-step guide. Quick and easy process.

Affected Component

Electrical

Estimated Time

10 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in a safe location and the engine is turned off before performing these steps.

1
Ensure the vehicle is in the 'Off' position and all doors are closed.
2
Insert the key into the ignition (or press the 'Start' button without pressing the brake pedal).
3
Press the gas pedal three times within five seconds.
4
Turn the ignition to the 'On' position without starting the engine.
5
Observe if the maintenance light blinks and then turns off.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the vehicle is in the 'Off' position and all doors are closed.
2
Insert the key into the ignition (or press the 'Start' button without pressing the brake pedal).
3
Press the gas pedal three times within five seconds.
4
Turn the ignition to the 'On' position without starting the engine.
5
Observe if the maintenance light blinks and then turns off.

Solution

1. Preparation

2. Resetting the Maintenance Light

Insert Key/Start Button: Insert the key into the ignition or press the "Start" button without pressing the brake pedal.
Press Gas Pedal: Quickly press the accelerator pedal three times within five seconds.
Turn Ignition On: Turn the ignition to the "On" position without starting the engine.
Check Maintenance Light: Observe the maintenance light; it should blink and then turn off. If it stays on, repeat the steps.
Turn Off Ignition: Turn the ignition back to the "Off" position to complete the process.