how to reset the maintenance light on my Toyota RAV4 XA40 (2013-2018)

Toyota RAV4 XA40 (2013-2018)

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

400 words

Problem Statement

Learn how to reset the maintenance light on your 2013-2018 Toyota RAV4 XA40. Step-by-step guide to ensure your vehicle is ready for the road.

Affected Component

Electrical

Estimated Time

5-10 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in a safe location and the engine is off while performing this reset.

1
Ensure the vehicle is in the 'OFF' position.
2
Press and hold the 'Odometer/Trip' button on the instrument panel.
3
Turn the ignition key to the 'ON' position without starting the engine.
4
Continue to hold the 'Odometer/Trip' button until the maintenance light turns off (approximately 10 seconds).
5
Release the 'Odometer/Trip' button.
6
Turn the ignition back to 'OFF' and then start the vehicle to verify the reset.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position.
2
Press and hold the 'Odometer/Trip' button on the instrument panel.
3
Turn the ignition key to the 'ON' position without starting the engine.
4
Continue to hold the 'Odometer/Trip' button until the maintenance light turns off (approximately 10 seconds).
5
Release the 'Odometer/Trip' button.
6
Turn the ignition back to 'OFF' and then start the vehicle to verify the reset.

Solution

1. Preparation

Ensure that all maintenance tasks (oil change, filter replacements, etc.) have been completed before resetting the light.
Gather necessary tools: none required for this procedure.

2. Resetting the Maintenance Light

Turn Off the Vehicle: Make sure the vehicle is completely turned off.
Press and Hold the Button: Press and hold the "Odometer/Trip" button located on the instrument cluster.
Turn On the Ignition: With the button still held, turn the ignition key to the "ON" position but do not start the engine. In vehicles with a push-button start, press the "START" button twice without pressing the brake pedal.
Watch for the Light: Continue holding the button until the maintenance light blinks and then turns off. This should take about 10 seconds.
Release the Button: Once the light is off, release the "Odometer/Trip" button.
Verify Reset: Turn the ignition back to the "OFF" position, then start the vehicle to confirm that the maintenance light has been reset.