how to reset maintenance light on Toyota RAV4 XA40 (2013-2018)

Toyota RAV4 XA40 (2013-2018)

5-10 minutes

Time

easy

Difficulty

low

Severity

3 min read

410 words

Problem Statement

Learn how to reset the maintenance light on a 2013-2018 Toyota RAV4 XA40. Step-by-step guide for a quick and easy reset after maintenance.

Affected Component

Electrical

Estimated Time

5-10 minutes

Important safety information - read before proceeding

1
Start the vehicle and ensure the odometer is displayed (not trip A or B).
2
Turn off the ignition completely.
3
Press and hold the trip reset button on the instrument panel.
4
Turn the ignition to the 'ON' position without starting the engine while continuing to hold the trip reset button.
5
Wait for the odometer display to show '000000' or for the maintenance light to flash and turn off.
6
Release the trip reset button and turn the ignition off.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Start the vehicle and ensure the odometer is displayed (not trip A or B).
2
Turn off the ignition completely.
3
Press and hold the trip reset button on the instrument panel.
4
Turn the ignition to the 'ON' position without starting the engine while continuing to hold the trip reset button.
5
Wait for the odometer display to show '000000' or for the maintenance light to flash and turn off.
6
Release the trip reset button and turn the ignition off.

Solution

1. Preparation

2. Reset the Maintenance Light

Turn Off the Engine:
- Ensure the vehicle is completely off and in the "Park" position.
Display Odometer:
- Turn the ignition key to the "ON" position (do not start the engine).
- Press the trip reset button until the odometer is displayed.
Initiate Reset Sequence:
- Turn the ignition off.
- Press and hold the trip reset button.
Turn On Ignition:
- While holding the trip reset button, turn the ignition to the "ON" position (without starting the engine).
Complete the Reset:
- Hold the trip reset button until the odometer displays "000000" or the maintenance light flashes and turns off.
- Release the button.
Final Step:
- Turn the ignition off and then back on to ensure the maintenance light is no longer illuminated.