how to reset the tire pressure light on my Toyota RAV4 Fifth Generation (2019-present)

Toyota RAV4 Fifth Generation (2019-present)

15-30 minutes

Time

easy

Difficulty

medium

Severity

3 min read

452 words

Problem Statement

Learn how to reset the tire pressure light on your 2019-2023 Toyota RAV4. Step-by-step guide with diagnostic steps and safety tips.

Affected Component

Electrical

Estimated Time

15-30 minutes

Important safety information - read before proceeding

1
Check the tire pressures using a tire pressure gauge to ensure all tires are at the recommended PSI.
2
Inspect tires for visible damage or punctures.
3
Verify that the spare tire (if equipped with a TPMS sensor) is also adequately inflated.
4
Check if the vehicle’s tire pressure monitoring system (TPMS) has been triggered by a recent tire rotation or change.
5
Consult the vehicle's manual for specific reset instructions or procedures related to the TPMS.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

•None required for the reset procedure, but consider new TPMS sensors if needed.

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Check the tire pressures using a tire pressure gauge to ensure all tires are at the recommended PSI.
2
Inspect tires for visible damage or punctures.
3
Verify that the spare tire (if equipped with a TPMS sensor) is also adequately inflated.
4
Check if the vehicle’s tire pressure monitoring system (TPMS) has been triggered by a recent tire rotation or change.
5
Consult the vehicle's manual for specific reset instructions or procedures related to the TPMS.

Solution

1. Preparation

Ensure all tires are inflated to the recommended pressure (refer to the sticker inside the driver's side door for specifications).
Gather necessary tools: tire pressure gauge and vehicle key.

2. Reset the Tire Pressure Monitoring System (TPMS)

Locate the TPMS Reset Button:
- The TPMS reset button is typically found under the dashboard or near the steering column.
Turn On the Ignition:
- Insert the key and turn the ignition to the "ON" position, but do not start the engine.
Press and Hold the TPMS Reset Button:
- Press and hold the reset button until the tire pressure light blinks three times. Release the button afterward.
Start the Vehicle:
- Start the engine and let it run for a few minutes. The tire pressure light should turn off if the reset was successful.
Check Dashboard Indicators:
- After driving for a short distance, ensure the tire pressure light remains off. If it stays on, recheck tire pressures and repeat the reset procedure.