how to reset the maintenance light on Toyota RAV4 Fourth Generation (2013-2018)

Toyota RAV4 Fourth Generation (2013-2018)

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

380 words

Problem Statement

Learn how to reset the maintenance light on your Toyota RAV4 Fourth Generation (2013-2018) with this easy step-by-step guide.

Affected Component

Electrical

Estimated Time

5-10 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' and on a flat surface before resetting the maintenance light.

1
Ensure the vehicle is parked and in the 'ON' position without starting the engine.
2
Check that the odometer is displaying the total mileage, not trip mileage.
3
Turn the ignition switch to the 'OFF' position.
4
Press and hold the odometer reset button.
5
While holding the reset button, turn the ignition switch back to the 'ON' position.
6
Continue holding the reset button until the maintenance light blinks and then turns off.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the vehicle is parked and in the 'ON' position without starting the engine.
2
Check that the odometer is displaying the total mileage, not trip mileage.
3
Turn the ignition switch to the 'OFF' position.
4
Press and hold the odometer reset button.
5
While holding the reset button, turn the ignition switch back to the 'ON' position.
6
Continue holding the reset button until the maintenance light blinks and then turns off.

Solution

1. Preparation

Gather necessary items: vehicle key, and ensure the vehicle is in a safe, quiet area.
Ensure all doors are closed, and the vehicle is in "Park" mode.

2. Resetting the Maintenance Light

Turn Off the Ignition
- Turn the ignition switch to the "OFF" position.
Prepare the Odometer
- Press and hold the odometer reset button located on the instrument panel. This button is typically on the right side of the speedometer.
Turn On the Ignition
- While still holding the odometer reset button, turn the ignition switch to the "ON" position without starting the engine.
Hold the Button
- Keep holding the odometer reset button; watch for the maintenance light to blink.
Completion of Reset
- Release the odometer reset button once the maintenance light turns off. This indicates that the reset is complete.