how to reset the maintenance light on my Toyota RAV4 Fourth Generation (2013-2018)

Toyota RAV4 Fourth Generation (2013-2018)

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

382 words

Problem Statement

Learn how to reset the maintenance light on your 2013-2018 Toyota RAV4. Step-by-step guide to ensure your service reminder is cleared.

Affected Component

Electrical

Estimated Time

5-10 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' and the engine is off before performing the reset procedure.

1
Turn the ignition key to the 'OFF' position.
2
Press and hold the odometer button on the instrument cluster.
3
While holding the odometer button, turn the ignition key to the 'ON' position (do not start the engine).
4
Continue holding the odometer button until the maintenance light resets, usually indicated by a flashing or turning off of the light.
5
Release the odometer button and turn the ignition back to the 'OFF' position.
6
Start the engine to verify that the maintenance light is no longer illuminated.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Turn the ignition key to the 'OFF' position.
2
Press and hold the odometer button on the instrument cluster.
3
While holding the odometer button, turn the ignition key to the 'ON' position (do not start the engine).
4
Continue holding the odometer button until the maintenance light resets, usually indicated by a flashing or turning off of the light.
5
Release the odometer button and turn the ignition back to the 'OFF' position.
6
Start the engine to verify that the maintenance light is no longer illuminated.

Solution

1. Preparation

2. Reset Maintenance Light

Turn Ignition Off: Ensure the ignition is in the "OFF" position.
Press and Hold Odometer Button: Locate the odometer button on the dashboard and press it, holding it down.
Turn Ignition On: While still holding the odometer button, turn the ignition key to the "ON" position without starting the engine.
Wait for the Reset: Keep holding the odometer button until the maintenance light starts flashing and then turns off (this usually takes about 10 seconds).
Release Odometer Button: Let go of the odometer button once the maintenance light has been reset.
Turn Ignition Off Again: Switch the ignition back to the "OFF" position.
Start Engine: Start the vehicle to ensure the maintenance light is off.