how to reset the maintenance light on Toyota Highlander XU70 (2020-Present)

Toyota Highlander XU70 (2020-Present)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

339 words

Problem Statement

Learn how to reset the maintenance light on your 2020-present Toyota Highlander XU70. Step-by-step guide for a quick and easy reset.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' or 'Neutral' and on a flat surface before resetting the light.

Symptoms

•Maintenance light illuminated on the dashboard
•Reminder for scheduled maintenance displayed
•No engine performance issues associated with the light

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position.
2
Turn the ignition switch to the 'ON' position without starting the engine.
3
Press the gas pedal three times within five seconds.
4
Turn the ignition switch back to the 'OFF' position.
5
Turn the ignition switch back to the 'ON' position to verify the reset.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None specifically required, but a floor mat may be used for comfort

Parts Required

•None

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather necessary tools (if needed, such as a floor mat for comfort).
Ensure the vehicle is parked on a level surface with the engine off.

2. Ignition Position

Insert the key into the ignition or ensure the vehicle is in the “RUN” mode if equipped with a push-start button.
Do not start the engine.

3. Resetting the Maintenance Light

Press the gas pedal three times quickly within five seconds.
Ensure the pedal is fully pressed each time for the reset to register.

4. Confirming the Reset

Turn the ignition switch to the "OFF" position after the gas pedal presses.
Turn the ignition switch back to the "ON" position (not starting the engine) and check that the maintenance light is no longer illuminated.