how to reset the maintenance light on a Toyota Highlander XU70 (2020-Present)

Toyota Highlander XU70 (2020-Present)

Error Codes

10-15 minutes

Time

easy

Difficulty

low

Severity

3 min read

426 words

Problem Statement

Learn how to reset the maintenance light on your 2020-present Toyota Highlander XU70. Follow our step-by-step guide for a quick and easy fix.

Affected Component

Electrical

Estimated Time

10-15 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in a secure, stationary position before performing the reset.

Symptoms

•Maintenance light illuminated on the dashboard
•Reminder message displayed regarding upcoming service
•No impact on vehicle performance, but notification persists

Diagnostic Steps

1
Turn the ignition switch to the 'ON' position without starting the engine.
2
Ensure that the trip meter is set to 'Trip A.' If not, toggle the trip meter until 'Trip A' is displayed.
3
Turn off the ignition.
4
Press and hold the 'Trip' button on the instrument panel.
5
While holding the 'Trip' button, turn the ignition switch back to the 'ON' position.
6
Continue to hold the 'Trip' button until the maintenance light resets and the odometer displays '000000.'

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None required for resetting the maintenance light.

Parts Required

•None required for resetting the maintenance light.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Turn the ignition switch to the 'ON' position without starting the engine.
2
Ensure that the trip meter is set to 'Trip A.' If not, toggle the trip meter until 'Trip A' is displayed.
3
Turn off the ignition.
4
Press and hold the 'Trip' button on the instrument panel.
5
While holding the 'Trip' button, turn the ignition switch back to the 'ON' position.
6
Continue to hold the 'Trip' button until the maintenance light resets and the odometer displays '000000.'

Solution

1. Preparation

Gather all necessary tools and ensure the vehicle is in a safe and stationary position.
Confirm that the vehicle's battery is charged and functioning properly.

2. Access the Ignition

Insert the key into the ignition switch or ensure the key fob is inside the vehicle for push-button start models.

3. Set Trip Meter

Turn the ignition to the "ON" position without starting the engine.
Verify that the trip meter is set to "Trip A."
If necessary, use the odometer reset button to toggle to "Trip A."

4. Turn Off Ignition

Switch off the ignition completely.

5. Reset Maintenance Light

Press and hold the "Trip" button on the instrument panel.
While holding the button, turn the ignition back to the "ON" position.
Keep holding the "Trip" button until the maintenance light goes off and the odometer shows "000000."

6. Finalize

Release the "Trip" button and turn off the ignition again.
Start the vehicle to ensure the maintenance light is no longer illuminated.