how to reset the maintenance light on Toyota Highlander Fourth Generation (2020-present)

Toyota Highlander Fourth Generation (2020-present)

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

398 words

Problem Statement

Learn how to reset the maintenance light on your 2020-2023 Toyota Highlander. Step-by-step guide to clear maintenance reminders effectively.

Affected Component

Electrical

Estimated Time

5-10 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in a safe location and the ignition is off when not in use.

•Maintenance light illuminated on the dashboard
•Notification for scheduled maintenance displayed on the multi-information display
•Vehicle's dashboard showing reminders for oil change or service due

1
Turn the ignition key to the 'ON' position without starting the engine.
2
Navigate to the odometer display using the trip meter button.
3
Ensure that the odometer is set to display total mileage (not trip A or trip B).
4
Turn off the ignition completely.
5
Press and hold the trip meter reset button while turning the ignition back to the 'ON' position.
6
Continue holding the trip meter reset button until the maintenance light resets, usually indicated by the light blinking and then turning off.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Turn the ignition key to the 'ON' position without starting the engine.
2
Navigate to the odometer display using the trip meter button.
3
Ensure that the odometer is set to display total mileage (not trip A or trip B).
4
Turn off the ignition completely.
5
Press and hold the trip meter reset button while turning the ignition back to the 'ON' position.
6
Continue holding the trip meter reset button until the maintenance light resets, usually indicated by the light blinking and then turning off.

Solution

1. Preparation

2. Reset Maintenance Light

Turn Ignition On
- Insert the key and turn it to the "ON" position (do not start the engine).
Display Odometer
- Use the trip meter button to toggle until the total odometer mileage is displayed.
Turn Off Ignition
- Completely turn off the ignition.
Press Trip Meter Reset
- Press and hold the trip meter reset button.
Turn Ignition Back On
- While holding the button, turn the ignition back to the "ON" position.
Release and Confirm Reset
- Release the trip meter reset button once the maintenance light blinks and turns off.