how to fix my Toyota Highlander power windows not working

Toyota Highlander Fourth Generation (2020-present)

Error Codes

1-3 hours

Time

medium

Difficulty

medium

Severity

3 min read

510 words

Problem Statement

Learn how to diagnose and fix power windows not working in Toyota Highlander. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Electrical

Estimated Time

1-3 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems to avoid short circuits or shocks.

Symptoms

•Power window switches do not respond when pressed
•Windows may be stuck in the closed or open position
•No sound (clicking or motor noise) from window motors
•Possible blown fuse indicated by other electrical issues
•Driver's side master switch may be unresponsive

Diagnostic Steps

1
Inspect the power window fuse in the fuse box for any signs of damage or failure.
2
Use a multimeter to check for voltage at the window switch when activated.
3
Test the individual window motors by applying direct power to them.
4
Inspect wiring and connections for signs of damage or corrosion.
5
Check the master window switch for functionality by testing each switch position.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Socket set
•Multimeter
•Flathead screwdriver
•Fuse puller or pliers

Parts Required

•Replacement fuse (if necessary)
•Replacement window switch (if faulty)
•Replacement window motor (if defective)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the power window fuse in the fuse box for any signs of damage or failure.
2
Use a multimeter to check for voltage at the window switch when activated.
3
Test the individual window motors by applying direct power to them.
4
Inspect wiring and connections for signs of damage or corrosion.
5
Check the master window switch for functionality by testing each switch position.

Solution

1. Preparation

Gather tools: socket set, multimeter, flathead screwdriver, and a replacement fuse if necessary.
Ensure the vehicle is parked and the ignition is off.

2. Inspect and Replace the Fuse

Locate the fuse box, typically found under the dashboard or in the engine compartment.
Remove the fuse panel cover and identify the power window fuse using the diagram inside the panel.
Use a fuse puller or pliers to remove the fuse and inspect it. If the filament is broken, replace it with a fuse of the same amperage rating.
Reinstall the fuse panel cover securely.

3. Test the Window Switches

Remove the door panel using a flathead screwdriver to carefully pry off clips and screws securing it.
Disconnect the window switch connector.
Use a multimeter to check for continuity in each switch position. Replace the switch if continuity is not present.

4. Inspect and Test the Window Motors

With the door panel removed, locate the window motor.
Disconnect the motor's electrical connector.
Apply direct battery power to the motor terminals using jumper wires (ensure proper polarity).
If the motor operates, it is functioning correctly; if not, it may need replacement.

5. Reassemble and Test

Reinstall the door panel securely, ensuring all clips and screws are in place.
Test all windows using the master control switch to confirm functionality.