how to change the battery in my Toyota Highlander Fourth Generation (2020-present) key fob

Toyota Highlander Fourth Generation (2020-present)

Error Codes

10-15 minutes

Time

easy

Difficulty

low

Severity

3 min read

455 words

Problem Statement

Learn how to change the battery in your Toyota Highlander Fourth Generation key fob. Step-by-step instructions for a quick and easy replacement.

Affected Component

Electrical

Estimated Time

10-15 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Dispose of old batteries responsibly, following local regulations for battery disposal.

Symptoms

•Key fob not responding to lock/unlock commands
•Key fob range significantly decreased
•Key fob LED indicator not lighting up when buttons are pressed
•Warning message on the dashboard indicating low key fob battery

Diagnostic Steps

1
Inspect the key fob for physical damage or signs of wear.
2
Verify that the key fob battery is indeed dead by trying to operate the fob from various distances.
3
Check for battery life using a multimeter if available.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Small flathead screwdriver
•Clean cloth

Parts Required

•CR2032 battery (replacement)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Ensure you have a replacement battery (CR2032) ready.
Gather necessary tools: small flathead screwdriver and a clean cloth.
Work in a clean area to prevent losing small components.

2. Open the Key Fob

Locate the small notch on the seam of the key fob.
Insert the small flathead screwdriver into the notch and gently twist to pry the fob open.
Take care not to damage the plastic casing during this process.

3. Remove the Old Battery

Carefully lift the old battery out of its compartment. Note the orientation of the battery (positive side facing up).
Dispose of the old battery according to local regulations.

4. Install the New Battery

Place the new CR2032 battery into the compartment, ensuring the positive side (+) is facing up.
Press down gently to secure the battery in place.

5. Reassemble the Key Fob

Align the two halves of the key fob.
Press firmly around the edges to snap the fob back together until you hear a click.
Ensure there are no gaps between the two halves.

6. Test the Key Fob

Stand within proximity of the vehicle and test the key fob by pressing the lock/unlock buttons.
Verify that the LED indicator lights up when buttons are pressed.