how can I reset the maintenance light on my Toyota Highlander Fourth Generation (2020-present)?

Toyota Highlander Fourth Generation (2020-present)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

314 words

Problem Statement

Learn how to reset the maintenance light on your Toyota Highlander (2020-present) with this simple step-by-step guide. Quick and easy instructions.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is stationary and in 'Park' mode before proceeding with the reset.

Symptoms

•Maintenance light illuminated on the dashboard
•Vehicle may display a 'Maintenance Required' message
•No engine performance issues are typically related

Diagnostic Steps

1
Ensure the vehicle is parked and the engine is turned off.
2
Turn the ignition key to the 'ON' position without starting the engine (or press the start button twice without pressing the brake pedal).
3
Press the gas pedal three times within five seconds.
4
Check if the maintenance light blinks and then turns off.
5
Turn off the ignition to complete the reset process.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None

Parts Required

•None

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Ensure the vehicle is parked and the engine is turned off.
2
Turn the ignition key to the 'ON' position without starting the engine (or press the start button twice without pressing the brake pedal).
3
Press the gas pedal three times within five seconds.
4
Check if the maintenance light blinks and then turns off.
5
Turn off the ignition to complete the reset process.

Solution

1. Preparation

Gather necessary tools: None required for this procedure.
Ensure the vehicle is in a safe, well-ventilated area.

2. Ignition Position

Insert the key and turn it to the "ON" position, or press the start button twice without starting the engine.

3. Gas Pedal Action

Press the gas pedal down to the floor three times within five seconds.
Observe the dashboard for any changes in the maintenance light.

4. Verification of Reset

After the third pedal press, observe if the maintenance light blinks and then turns off.
Turn off the ignition to finalize the reset.