how to reset the tire pressure light on my Toyota Highlander Third Generation (2014-2019)

Toyota Highlander Third Generation (2014-2019)

15-30 minutes

Time

easy

Difficulty

medium

Severity

2 min read

383 words

Problem Statement

Learn how to reset the tire pressure light on your 2014-2019 Toyota Highlander. Step-by-step guide with diagnostic steps and safety tips.

Affected Component

Electrical

Estimated Time

15-30 minutes

Important safety information - read before proceeding

•Ensure the vehicle is parked on a level surface before checking tire pressures.

1
Check the current tire pressures using a tire pressure gauge to ensure all tires are properly inflated.
2
Inspect each tire for visible damage or leaks.
3
Verify if the spare tire is included in the tire pressure monitoring system (TPMS) and check its pressure if applicable.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Solution

1. Preparation

Gather necessary tools: tire pressure gauge, vehicle owner's manual.
Ensure all tires are inflated to the recommended PSI listed on the driver's side door jamb.

2. Reset the Tire Pressure Monitoring System (TPMS)

Locate the TPMS Reset Button:
- The reset button is typically found beneath the steering wheel or in the glove compartment.
Turn On the Ignition:
- Insert the key or push the start button to turn on the ignition without starting the engine (accessory mode).
Press the TPMS Reset Button:
- Press and hold the TPMS reset button until the tire pressure light blinks three times, then release it.
Wait for the System to Initialize:
- Drive the vehicle for a few minutes at speeds over 25 mph to allow the system to recalibrate.

3. Final Check