how to reset the maintenance light on Toyota Highlander Third Generation (2014-2019)?

Toyota Highlander Third Generation (2014-2019)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

3 min read

418 words

Problem Statement

Learn how to reset the maintenance light on a 2014-2019 Toyota Highlander. Step-by-step guide to ensure your maintenance records are cleared.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in park and on a flat surface before performing any resets.

Symptoms

•Maintenance light illuminated on the dashboard
•Reminder message displayed on the screen
•Previous maintenance records not cleared

Diagnostic Steps

1
Turn the ignition key to the 'ON' position without starting the engine.
2
Ensure that the odometer display is showing the total mileage, not the trip mileage.
3
Turn off the ignition.
4
Press and hold the trip reset button on the instrument panel.
5
While holding the trip reset button, turn the ignition back to the 'ON' position.
6
Continue holding the trip reset button until the maintenance light blinks and then turns off.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Vehicle key or key fob

Parts Required

•None required for this procedure.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Turn the ignition key to the 'ON' position without starting the engine.
2
Ensure that the odometer display is showing the total mileage, not the trip mileage.
3
Turn off the ignition.
4
Press and hold the trip reset button on the instrument panel.
5
While holding the trip reset button, turn the ignition back to the 'ON' position.
6
Continue holding the trip reset button until the maintenance light blinks and then turns off.

Solution

1. Preparation

Gather all necessary tools and materials for the reset.
Ensure the vehicle is parked safely and the ignition is off.

2. Access the Ignition

Insert the key into the ignition or ensure the key fob is ready for push-start.
Position the vehicle in a well-lit area for visibility.

3. Reset the Maintenance Light

Turn the ignition key to the "ON" position without starting the engine.
Check the odometer display; it should show the total mileage.
Turn off the ignition completely.
Press and hold the trip reset button located on the instrument panel (usually near the odometer).
While holding the trip reset button, turn the ignition back to the "ON" position.
Hold the trip reset button until the maintenance light blinks and then goes off, usually taking about 10 seconds.
Release the trip reset button once the light is off.

4. Confirm the Reset

Turn off the ignition and then start the vehicle to verify that the maintenance light is no longer illuminated.