how to reset the maintenance light on Toyota Highlander Third Generation (2014-2019)

Toyota Highlander Third Generation (2014-2019)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

386 words

Problem Statement

Learn how to reset the maintenance light on a 2014-2019 Toyota Highlander. Step-by-step guide to ensure your vehicle's maintenance reminders are accurate.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' or 'Neutral' and on a level surface when performing the reset.

Symptoms

•Maintenance light remains illuminated after service
•Potentially incorrect service interval reminders
•User receives notifications for routine maintenance

Diagnostic Steps

1
Turn the ignition switch to the 'ON' position without starting the engine.
2
Ensure the odometer is displayed on the multi-information display.
3
Turn the ignition switch off.
4
Press and hold the trip meter reset button.
5
Turn the ignition switch back to the 'ON' position while continuing to hold the trip meter reset button.
6
Release the button once the maintenance light resets (the maintenance light should blink and then turn off).

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None

Parts Required

•None

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Turn the ignition switch to the 'ON' position without starting the engine.
2
Ensure the odometer is displayed on the multi-information display.
3
Turn the ignition switch off.
4
Press and hold the trip meter reset button.
5
Turn the ignition switch back to the 'ON' position while continuing to hold the trip meter reset button.
6
Release the button once the maintenance light resets (the maintenance light should blink and then turn off).

Solution

1. Preparation

Gather necessary tools: None required for this procedure.
Ensure the vehicle is in a safe location with the engine off.

2. Reset the Maintenance Light

Turn Ignition On: Turn the ignition switch to the "ON" position without starting the engine.
Check Odometer: Make sure the odometer is displayed on the dashboard. If not, use the "Display" button to toggle to the odometer reading.
Turn Off Ignition: Turn the ignition switch off.
Press Trip Meter Reset Button: Locate the trip meter reset button, usually on the instrument panel, and press and hold it.
Turn Ignition On Again: While holding the trip meter reset button, turn the ignition switch back to the "ON" position but do not start the engine.
Release Button: Continue holding the button until the maintenance light blinks and then turns off, which indicates that the reset was successful.