how to reset the maintenance light on Toyota Highlander Third Generation (2014-2019)

Toyota Highlander Third Generation (2014-2019)

Error Codes

10 minutes

Time

easy

Difficulty

low

Severity

2 min read

388 words

Problem Statement

Learn how to reset the maintenance light on your 2014-2019 Toyota Highlander. Step-by-step guide to ensure your vehicle is ready for the road.

Affected Component

Electrical

Estimated Time

10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is stationary and parked in a safe area while performing this procedure.

Symptoms

•Maintenance light is illuminated on the dashboard
•Vehicle may indicate scheduled maintenance is due
•No changes in vehicle performance are typically observed

Diagnostic Steps

1
Ensure the vehicle is in the 'ON' position without starting the engine.
2
Locate the trip meter reset button on the dashboard.
3
Turn the ignition switch to the 'OFF' position.
4
Press and hold the trip meter reset button while turning the ignition back to the 'ON' position.
5
Continue holding the trip meter reset button until the maintenance light resets (approximately 10 seconds).
6
Release the trip meter reset button and verify the maintenance light is no longer illuminated.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Vehicle key

Parts Required

•None

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Ensure the vehicle is in the 'ON' position without starting the engine.
2
Locate the trip meter reset button on the dashboard.
3
Turn the ignition switch to the 'OFF' position.
4
Press and hold the trip meter reset button while turning the ignition back to the 'ON' position.
5
Continue holding the trip meter reset button until the maintenance light resets (approximately 10 seconds).
6
Release the trip meter reset button and verify the maintenance light is no longer illuminated.

Solution

1. Preparation

Gather necessary materials: vehicle keys.
Ensure all doors are closed and the vehicle is in a safe, stationary position.

2. Turn Ignition to "ON"

Insert the key into the ignition and turn it to the "ON" position (do not start the engine).

3. Reset the Trip Meter

Locate the trip meter reset button on the instrument panel.
Press and hold the trip meter reset button.

4. Turn Ignition Off and On

While holding the trip meter reset button, turn the ignition switch back to the "OFF" position.
Then turn the ignition switch back to the "ON" position while still holding the button.

5. Confirm Reset

Keep holding the trip meter reset button until the maintenance light turns off (about 10 seconds).
Release the button once the light is off.