how to reset the maint reqd light on my Toyota Highlander Third Generation (2014-2019)

Toyota Highlander Third Generation (2014-2019)

Error Codes

Less than 15 minutes

Time

easy

Difficulty

low

Severity

2 min read

340 words

Problem Statement

Learn how to reset the maintenance required light on your 2014-2019 Toyota Highlander. Step-by-step guide for quick and easy reset.

Affected Component

Electrical

Estimated Time

Less than 15 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' mode to prevent any movement during the procedure.

Symptoms

•Maintenance required light is illuminated on the dashboard
•Possible reminder for oil change or other routine services
•No engine performance issues related to the light itself

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position.
2
Turn the ignition key to the 'ON' position without starting the engine.
3
Press the gas pedal three times within five seconds.
4
Turn the ignition switch to the 'OFF' position.
5
Start the engine to verify if the maintenance required light is no longer illuminated.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None needed for resetting the maintenance light.

Parts Required

•None needed for resetting the maintenance light.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position.
2
Turn the ignition key to the 'ON' position without starting the engine.
3
Press the gas pedal three times within five seconds.
4
Turn the ignition switch to the 'OFF' position.
5
Start the engine to verify if the maintenance required light is no longer illuminated.

Solution

1. Preparation

Gather necessary tools: None required for this procedure.
Ensure the vehicle is parked on a level surface and in "Park" mode.

2. Ignition Sequence

Turn the ignition key to the "OFF" position.
Turn the ignition key to "ON" (do not start the engine).
Observe the dashboard for the maintenance required light.

3. Reset Procedure

Press the gas pedal down slowly three times within five seconds.
After the third press, the maintenance required light should blink and then turn off.

4. Final Steps

Turn the ignition key back to the "OFF" position.
Start the vehicle to ensure the maintenance required light is reset.