how do I reset the maintenance light on my Toyota Highlander Third Generation (2014-2019)

Toyota Highlander Third Generation (2014-2019)

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

331 words

Problem Statement

Learn how to reset the maintenance light on your Toyota Highlander (2014-2019) with this easy step-by-step guide. No tools required.

Affected Component

Electrical

Estimated Time

5-10 minutes

Important safety information - read before proceeding

1
Ensure the vehicle is in the 'Off' position and the key is removed from the ignition.
2
Insert the key into the ignition without starting the engine.
3
Press the gas pedal three times within five seconds while the key is in the 'On' position (not starting the engine).
4
Observe the maintenance light to confirm that it has turned off.
5
Turn the ignition off and remove the key.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the vehicle is in the 'Off' position and the key is removed from the ignition.
2
Insert the key into the ignition without starting the engine.
3
Press the gas pedal three times within five seconds while the key is in the 'On' position (not starting the engine).
4
Observe the maintenance light to confirm that it has turned off.
5
Turn the ignition off and remove the key.

Solution

1. Preparation

2. Reset Maintenance Light

Insert Key: Place the key in the ignition.
Turn to On Position: Turn the key to the "On" position without starting the engine.
Press Gas Pedal: Press the gas pedal down three times within five seconds. This action should trigger the reset process.
Check Light: Observe the maintenance light on the dashboard. It should turn off.
Turn Off Ignition: Turn the key back to the "Off" position and remove it.