how to reset the maintenance light on my Toyota Corolla E210 (2019-2024)

Toyota Corolla E210 (2019-2024)

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

381 words

Problem Statement

Learn how to reset the maintenance light on your 2019-2024 Toyota Corolla E210. Follow our step-by-step guide for a quick and easy reset.

Affected Component

Electrical

Estimated Time

5-10 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in a safe position to avoid any accidents during the reset process.

1
Ensure the vehicle is in the 'OFF' position before beginning the reset process.
2
Insert the key into the ignition (or press the start button without pressing the brake pedal for push-to-start vehicles).
3
Press and hold the 'Trip' or 'Odometer' button until the trip meter displays '000000.'
4
Turn the ignition to the 'ON' position without starting the engine.
5
Continue to hold the 'Trip' or 'Odometer' button for about 10 seconds until the maintenance light blinks and then turns off.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position before beginning the reset process.
2
Insert the key into the ignition (or press the start button without pressing the brake pedal for push-to-start vehicles).
3
Press and hold the 'Trip' or 'Odometer' button until the trip meter displays '000000.'
4
Turn the ignition to the 'ON' position without starting the engine.
5
Continue to hold the 'Trip' or 'Odometer' button for about 10 seconds until the maintenance light blinks and then turns off.

Solution

1. Preparation

2. Resetting the Maintenance Light

Turn Off the Ignition
- Ensure the engine is completely off before proceeding.
Prepare the Odometer
- Press and hold the "Trip" or "Odometer" button on the instrument cluster.
Ignition Cycle
- With the button still pressed, turn the ignition key to the "ON" position (do not start the engine).
Hold for 10 Seconds
- Continue holding the button for approximately 10 seconds until the maintenance light blinks and then goes out.
Release the Button
- Once the light is off, you can release the "Trip" or "Odometer" button.