how do I reset the tire pressure light on my Toyota Corolla E210 (2019-2024)

Toyota Corolla E210 (2019-2024)

30 minutes

Time

easy

Difficulty

medium

Severity

2 min read

359 words

Problem Statement

Learn how to reset the tire pressure light on your 2019-2024 Toyota Corolla E210. Step-by-step guide with diagnostic steps and solutions.

Affected Component

Electrical

Estimated Time

30 minutes

Important safety information - read before proceeding

•Ensure the vehicle is parked on a flat, stable surface before checking tire pressures.

1
Verify that all tires are properly inflated to the manufacturer's specifications.
2
Check the vehicle's owner's manual for the specific reset procedure for the tire pressure monitoring system (TPMS).
3
Inspect each tire for any visible damage or leaks.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Solution

1. Tire Pressure Check

Sub-steps:
1. Use a tire pressure gauge to check the pressure in all four tires.
2. Inflate or deflate the tires as necessary to reach the recommended PSI listed on the driver's door jamb or in the owner's manual.

2. Reset Tire Pressure Monitoring System

Sub-steps:
1. Turn the ignition switch to the "ON" position (do not start the engine).
2. Locate the TPMS reset button, usually found below the steering wheel or on the dashboard.
3. Press and hold the TPMS reset button until the tire pressure light blinks three times, then release the button.
4. Start the engine and allow the vehicle to run for a few minutes to confirm the reset.

3. Verify Reset

Sub-steps:
1. Turn off the engine and then restart to ensure the tire pressure light remains off.
2. Drive the vehicle for a short distance to confirm that the TPMS light does not re-illuminate.