why does my Toyota Corolla E170 (2013-2019) check engine light keep coming on

Toyota Corolla E170 (2013-2019)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

474 words

Problem Statement

Learn how to diagnose and fix the check engine light issue on a 2013-2019 Toyota Corolla E170. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Engine

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect battery before working on electrical systems.
•Allow engine to cool before opening any components.

Symptoms

•Check engine light illuminated
•Rough idling or stalling
•Decreased fuel efficiency
•Increased emissions
•Engine misfires or hesitation during acceleration

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner to identify specific issues.
2
Inspect the vehicle’s gas cap for cracks or improper sealing.
3
Check engine oil and coolant levels for any abnormalities.
4
Examine the air filter for clogs or dirt.
5
Test the ignition system components (spark plugs, coils) for proper operation.
6
Inspect exhaust system for leaks or blockages.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Socket set
•Torque wrench
•Spark plug socket
•Screwdrivers

Parts Required

•Gas cap (if faulty)
•Spark plugs (if worn)
•Air filter (if dirty)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner to identify specific issues.
2
Inspect the vehicle’s gas cap for cracks or improper sealing.
3
Check engine oil and coolant levels for any abnormalities.
4
Examine the air filter for clogs or dirt.
5
Test the ignition system components (spark plugs, coils) for proper operation.
6
Inspect exhaust system for leaks or blockages.

Solution

1. Preparation

Gather necessary tools and parts.
Disconnect the battery to ensure safety while working on electrical components.

2. Address Error Codes

Using the OBD-II scanner, note any error codes.
Research the codes to identify potential issues and prioritize repairs based on severity.

3. Inspect and Replace Gas Cap

Remove the gas cap and inspect for damage or dirt.
Clean the sealing surface and replace the gas cap if necessary.
Tighten the new gas cap until it clicks.

4. Check and Replace Spark Plugs

Remove ignition coil(s) using a socket wrench.
Take out the spark plugs using a spark plug socket.
Inspect spark plugs for wear or fouling; replace if necessary.
Reinstall the spark plugs and ignition coils, torqueing to manufacturer specifications.

5. Check Air Filter

Locate the air filter housing and open it.
Remove the air filter, inspecting for dirt and wear.
Replace with a new air filter if needed, ensuring a snug fit.

6. Inspect Exhaust System

Visually inspect the exhaust system for any signs of leaks or damage.
Use a smoke test if necessary to detect hidden leaks.
Repair or replace damaged components as required.