Toyota Corolla E170 (2013-2019) engine making clicking noise what to do

Toyota Corolla E170 (2013-2019)

Error Codes

2-4 hours

Time

medium

Difficulty

medium

Severity

3 min read

572 words

Problem Statement

Learn how to diagnose and fix engine clicking noise in Toyota Corolla E170 (2013-2019). Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Engine

Estimated Time

2-4 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical components
•Allow the engine to cool before opening any engine components

Symptoms

•Clicking noise from the engine compartment, especially at idle or under load
•Possible loss of power during acceleration
•Engine misfires or rough running
•Increased oil consumption
•Check engine light illuminated

Diagnostic Steps

1
Scan for error codes using OBD-II scanner
2
Inspect engine oil level and condition
3
Listen for noise location to identify source
4
Check valve clearances of valve lifters
5
Inspect for loose components in the engine area
6
Perform a compression test in each cylinder

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Socket set
•Torque wrench
•Compression gauge
•Oil filter wrench

Parts Required

•Engine oil (manufacturer-recommended type)
•Oil filter
•Valve lifters (if replacement is needed)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Tools Required:
- OBD-II scanner
- Socket set
- Torque wrench
- Compression gauge
Ensure the vehicle is parked on a level surface and the engine is cool.

2. Change Engine Oil and Filter

Sub-steps:
1. Drain Old Oil: Remove the oil drain plug and allow the old oil to completely drain into a pan.
2. Replace Oil Filter: Use an oil filter wrench to remove the old filter and install a new OEM filter, applying a small amount of oil to the rubber gasket.
3. Fill with New Oil: Replace the drain plug and fill the engine with the manufacturer-recommended oil type and quantity.
4. Start Engine: Run the engine for a few minutes to circulate the new oil and check for leaks.

3. Adjust or Replace Valve Lifters

Sub-steps:
1. Remove Valve Cover: Unbolt the valve cover and remove it carefully to access the valve train.
2. Inspect Lifters: Check each lifter for wear or damage. Replace any lifters that show signs of wear.
3. Adjust Clearance: If applicable, adjust the valve clearances according to the manufacturer's specifications.
4. Reinstall Valve Cover: Clean the mating surfaces, apply new gasket material, and torque the valve cover bolts to the specified value.

4. Tighten Loose Components

Sub-steps:
1. Inspect: Visually check all engine components, including heat shields and brackets, for looseness.
2. Tighten Bolts: Using the appropriate socket, tighten any loose bolts and ensure all components are secure.