my Toyota Corolla E170 (2013-2019) engine light keeps coming on, what should I do?

Toyota Corolla E170 (2013-2019)

Error Codes

1-3 hours

Time

medium

Difficulty

medium

Severity

3 min read

485 words

Problem Statement

Learn how to diagnose and fix the check engine light issue in a 2013-2019 Toyota Corolla E170. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Engine

Estimated Time

1-3 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical components.
•Allow the engine to cool before inspecting or removing parts to prevent burns.

Symptoms

•Check engine light illuminated
•Rough idle
•Decreased fuel efficiency
•Engine stalling
•Unusual noises from the engine

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner to identify specific trouble codes.
2
Inspect the gas cap for proper sealing and any signs of damage.
3
Check engine oil and coolant levels to ensure they are within normal ranges.
4
Visually inspect the engine for any obvious leaks, loose connections, or damaged components.
5
Test the battery voltage and connections to rule out electrical issues.
6
Review the most recent maintenance history for any potential impacts on engine performance.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Socket set
•Multimeter
•Basic hand tools

Parts Required

•Gas cap (if damaged)
•Spark plugs (if worn)
•Air filter (if dirty)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner to identify specific trouble codes.
2
Inspect the gas cap for proper sealing and any signs of damage.
3
Check engine oil and coolant levels to ensure they are within normal ranges.
4
Visually inspect the engine for any obvious leaks, loose connections, or damaged components.
5
Test the battery voltage and connections to rule out electrical issues.
6
Review the most recent maintenance history for any potential impacts on engine performance.

Solution

1. Preparation

Gather tools including an OBD-II scanner, socket set, multimeter, and basic hand tools.
Ensure the vehicle is parked on a level surface and the engine is cool.

2. Address Error Codes

Use the OBD-II scanner to read and document the trouble codes.
Research the codes to determine the potential causes and necessary repairs.

3. Inspect and Replace Components

Gas Cap:
- Remove the gas cap and inspect the rubber seal for wear; replace if damaged.
- Reinstall the cap and ensure it clicks into place securely.
Spark Plugs:
- Remove the ignition coils using a socket set.
- Inspect or replace spark plugs if fouling or excessive wear is observed.
- Reinstall ignition coils and ensure they are torqued to manufacturer specifications (usually around 7-10 ft-lbs).

4. Clean or Replace Air Filter

Remove the air filter cover and inspect the air filter for dirt or obstruction.
Replace with a new air filter if necessary, ensuring it is seated properly.

5. Reset the Check Engine Light

After completing repairs, reset the check engine light using the OBD-II scanner.
Alternatively, disconnect the negative battery terminal for 10 minutes to clear the codes.