how to reset the transmission light on my Toyota Corolla E170 (2013-2019)

Toyota Corolla E170 (2013-2019)

Error Codes

1-2 hours

Time

medium

Difficulty

medium

Severity

3 min read

476 words

Problem Statement

Learn how to reset the transmission light on your 2013-2019 Toyota Corolla E170. Step-by-step guide with diagnostic steps and solutions.

Affected Component

Transmission

Estimated Time

1-2 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems.
•Allow the engine to cool before checking the transmission fluid to avoid burns.

Symptoms

•Transmission warning light illuminated on the dashboard
•Possible erratic shifting behavior
•Delayed engagement of gears
•Engine stalling during shifts
•Reduced fuel efficiency

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner to identify specific transmission issues.
2
Inspect the transmission fluid level and condition (check for contamination or low levels).
3
Check for any visible leaks around the transmission and fluid lines.
4
Verify the operation of the transmission control module (TCM) and related sensors.
5
Perform a hard reset by disconnecting the battery for a few minutes.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Socket set
•Battery terminal wrench

Parts Required

•Toyota ATF WS transmission fluid (if low)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner to identify specific transmission issues.
2
Inspect the transmission fluid level and condition (check for contamination or low levels).
3
Check for any visible leaks around the transmission and fluid lines.
4
Verify the operation of the transmission control module (TCM) and related sensors.
5
Perform a hard reset by disconnecting the battery for a few minutes.

Solution

1. Preparation

Gather necessary tools: OBD-II scanner, socket set, and battery terminal wrench.
Ensure the vehicle is parked on a level surface and the engine is off.
Wear safety gloves and goggles.

2. Scan for Error Codes

Connect the OBD-II scanner to the vehicle’s diagnostic port (usually located under the dashboard).
Turn the ignition key to the "ON" position (do not start the engine).
Follow the scanner's instructions to retrieve and record any error codes related to the transmission.

3. Inspect Transmission Fluid

Locate the transmission dipstick (if equipped) or access the transmission fluid fill plug.
Withdraw the dipstick, clean it, and reinsert it to check the fluid level.
If low, add the appropriate type of transmission fluid as specified in the owner's manual (typically Toyota ATF WS).

4. Perform a Hard Reset

Turn off the ignition and disconnect the negative battery terminal using a socket wrench.
Wait for at least 15 minutes to allow the vehicle's systems to reset.
Reconnect the negative battery terminal securely.

5. Clear Error Codes

Reconnect the OBD-II scanner and select the option to clear error codes.
Turn the ignition to the "ON" position again and check that the transmission light is off.