how to reset the maintenance light on Toyota Corolla E170 (2013-2019)

Toyota Corolla E170 (2013-2019)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

377 words

Problem Statement

Learn how to reset the maintenance light on your 2013-2019 Toyota Corolla E170 with this step-by-step guide. Quick and easy instructions for a successful reset.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' or 'Neutral' and the parking brake is engaged before performing the reset procedure.

Symptoms

•Maintenance light is illuminated on the dashboard
•No other warning lights are present
•Engine runs normally but alerts for maintenance

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position and the odometer is displayed.
2
Turn the ignition key to the 'ON' position without starting the engine.
3
Press the gas pedal three times within five seconds.
4
Check if the maintenance light blinks and then turns off.
5
Turn the ignition back to the 'OFF' position and then start the vehicle to verify the reset.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None needed for this procedure.

Parts Required

•None needed for this procedure.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position and the odometer is displayed.
2
Turn the ignition key to the 'ON' position without starting the engine.
3
Press the gas pedal three times within five seconds.
4
Check if the maintenance light blinks and then turns off.
5
Turn the ignition back to the 'OFF' position and then start the vehicle to verify the reset.

Solution

1. Preparation

Gather necessary tools: None required for this procedure.
Ensure the vehicle is parked on a flat surface and the engine is off.

2. Turn Ignition On

Insert the key into the ignition and turn it to the "ON" position (do not start the engine).

3. Display Odometer

Ensure the odometer is visible on the dashboard display. If it shows trip mileage, press the trip button until the odometer reading appears.

4. Press Gas Pedal

Quickly press the gas pedal down three times within five seconds.
Observe the maintenance light; it should blink and then turn off.

5. Turn Ignition Off

Turn the ignition key back to the "OFF" position.

6. Start the Vehicle

Start the engine to confirm that the maintenance light is no longer illuminated.