how to reset the maintenance light on my Toyota Corolla E170 (2013-2019)

Toyota Corolla E170 (2013-2019)

5 minutes

Time

easy

Difficulty

low

Severity

2 min read

356 words

Problem Statement

Learn how to reset the maintenance light on your 2013-2019 Toyota Corolla E170 with this step-by-step guide. Quick and easy instructions included.

Affected Component

Electrical

Estimated Time

5 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in park and on a flat surface before performing the reset.

1
Ensure the vehicle is in the 'OFF' position.
2
Press and hold the odometer reset button on the instrument panel.
3
While holding the odometer button, turn the ignition switch to the 'ON' position (do not start the engine).
4
Continue holding the odometer button until the maintenance light blinks and then turns off.
5
Release the odometer button.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position.
2
Press and hold the odometer reset button on the instrument panel.
3
While holding the odometer button, turn the ignition switch to the 'ON' position (do not start the engine).
4
Continue holding the odometer button until the maintenance light blinks and then turns off.
5
Release the odometer button.

Solution

1. Preparation

2. Resetting the Maintenance Light

Turn the Ignition Off
- Confirm that the vehicle is completely off.
Press and Hold Odometer Reset Button
- Locate the odometer reset button, typically found on the dashboard near the speedometer.
- Press and hold the button.
Turn Ignition On
- While still holding the odometer button, turn the ignition key to the "ON" position without starting the engine.
- The dashboard lights will illuminate.
Wait for the Maintenance Light to Blink
- Continue holding the button until the maintenance light blinks and turns off, which usually takes a few seconds.
Release the Odometer Button
- Once the light is off, release the odometer reset button.
- Turn the ignition off, then start the vehicle to verify the maintenance light is no longer illuminated.