how to reset the maintenance light on my Toyota Corolla E170 (2013-2019)

Toyota Corolla E170 (2013-2019)

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

360 words

Problem Statement

Learn how to reset the maintenance light on your 2013-2019 Toyota Corolla E170 after completing maintenance. Step-by-step guide included.

Affected Component

Electrical

Estimated Time

5-10 minutes

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' before performing the reset to prevent unintended movement.

1
Ensure the ignition is turned off and the vehicle is in the 'Park' position.
2
Press and hold the odometer trip button located on the instrument cluster.
3
Turn the ignition key to the 'On' position without starting the engine.
4
Continue holding the odometer trip button until the maintenance light blinks and then turns off.
5
Release the odometer trip button.

After completing the repair, verify that the issue has been resolved:

To prevent this issue from occurring again:

No comments yet

Be the first to share your thoughts

Diagnostic Steps

1
Ensure the ignition is turned off and the vehicle is in the 'Park' position.
2
Press and hold the odometer trip button located on the instrument cluster.
3
Turn the ignition key to the 'On' position without starting the engine.
4
Continue holding the odometer trip button until the maintenance light blinks and then turns off.
5
Release the odometer trip button.

Solution

1. Preparation

2. Resetting the Maintenance Light

Locate the Odometer Trip Button:
- Find the button on the dashboard near the speedometer.
Hold the Button:
- Press and hold the odometer trip button.
Turn on the Ignition:
- Turn the ignition key to the "On" position (do not start the engine) while continuing to hold the button.
Observe the Maintenance Light:
- Keep holding the button until the maintenance light blinks and then turns off, which indicates the reset is successful.
Release the Button:
- Once the maintenance light is off, release the odometer trip button.
Verify Reset:
- Turn off the ignition and then start the vehicle to ensure the maintenance light does not illuminate again.