how to reset the maintenance light on my Toyota Corolla E170 (2013-2019)

Toyota Corolla E170 (2013-2019)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

2 min read

332 words

Problem Statement

Learn how to reset the maintenance light on your 2013-2019 Toyota Corolla E170. Step-by-step guide to ensure your dashboard is clear after maintenance.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is stationary and parked safely before performing the reset.

Symptoms

•Maintenance light illuminated on the dashboard
•No other warning lights present
•Vehicle maintenance has been completed

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position.
2
Turn the ignition key to the 'ON' position without starting the engine.
3
Press the gas pedal three times within five seconds.
4
Check if the maintenance light turns off.
5
Turn the ignition off and then back on to verify the light is reset.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None

Parts Required

•None

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather necessary tools: None required for this procedure.
Ensure the vehicle is parked in a safe location.

2. Ignition Control

Turn Off the Vehicle: Make sure the engine is completely off before beginning the reset process.
Ignition On: Insert the key and turn it to the "ON" position. Do not start the engine.

3. Reset the Maintenance Light

Press the Gas Pedal: Quickly press the gas pedal three times within five seconds while the ignition is in the "ON" position.
Check Light Status: Observe the maintenance light on the dashboard; it should turn off if successful.

4. Final Verification

Turn Off Ignition: After resetting the light, turn the ignition off completely.
Restart Vehicle: Turn the ignition back to the "ON" position to check that the maintenance light remains off.