how to reset the maintenance light on a Toyota Corolla E170 (2013-2019)

Toyota Corolla E170 (2013-2019)

Error Codes

10-15 minutes

Time

easy

Difficulty

low

Severity

2 min read

313 words

Problem Statement

Learn how to reset the maintenance light on a 2013-2019 Toyota Corolla E170. Step-by-step guide to ensure your vehicle is ready for the road.

Affected Component

Electrical

Estimated Time

10-15 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is parked on a level surface before performing the reset.

Symptoms

•Maintenance light illuminated on the dashboard
•Notification of maintenance due on the display screen
•No engine performance issues related to the light

Diagnostic Steps

1
Verify that the maintenance light is illuminated on the dashboard.
2
Ensure the vehicle is in the 'OFF' position.
3
Confirm that the odometer is set to the trip A reading (not the odometer total).

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None required

Parts Required

•None required

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Ensure the vehicle is in "OFF" position.
Make sure the keys are available.

2. Turn the Ignition On

Insert the key into the ignition.
Turn the key to the "ON" position without starting the engine (position II).

3. Reset the Maintenance Light

Press and hold the trip meter reset knob located on the instrument cluster.
While holding the knob, turn the ignition back to the "OFF" position.
Release the trip meter reset knob.
Turn the ignition back to the "ON" position again.
Continue to hold the trip meter reset knob until the maintenance light blinks and turns off, which typically takes about 10 seconds.

4. Verify Reset

Release the trip meter reset knob after the light turns off.
Turn off the ignition and then start the engine to ensure the maintenance light remains off.