how to reset the EPS light in my Toyota Corolla E170 (2013-2019)?

Toyota Corolla E170 (2013-2019)

Error Codes

1 hour

Time

medium

Difficulty

medium

Severity

3 min read

462 words

Problem Statement

Learn how to reset the EPS light in your 2013-2019 Toyota Corolla E170. Step-by-step guide with diagnostic steps and solutions for power steering issues.

Affected Component

Steering

Estimated Time

1 hour

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in park with the engine off before performing any inspections.

Symptoms

•EPS warning light illuminated on the dashboard
•Difficulty in steering, especially at low speeds
•Unusual noise coming from the steering column
•Steering wheel feels heavier than normal
•Temporary loss of power steering assist while driving

Diagnostic Steps

1
Inspect the power steering fluid level and condition.
2
Scan for error codes using an OBD-II scanner to identify any faults.
3
Check the steering column and associated wiring for damage or disconnections.
4
Verify the condition of the EPS motor and its electrical connections.
5
Clear any stored error codes using the OBD-II scanner.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Clean cloth
•Power steering fluid

Parts Required

•Power steering fluid

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Inspect the power steering fluid level and condition.
2
Scan for error codes using an OBD-II scanner to identify any faults.
3
Check the steering column and associated wiring for damage or disconnections.
4
Verify the condition of the EPS motor and its electrical connections.
5
Clear any stored error codes using the OBD-II scanner.

Solution

1. Preparation

Gather necessary tools: OBD-II scanner, a clean cloth, and possibly power steering fluid.
Ensure the vehicle is parked on a flat surface with the engine off.

2. Inspect Power Steering Fluid

Open the hood and locate the power steering fluid reservoir.
Check the fluid level against the markings on the reservoir.
If low, add the manufacturer-recommended power steering fluid to the appropriate level.

3. Use OBD-II Scanner

Connect the OBD-II scanner to the vehicle’s diagnostic port, typically located under the dashboard.
Turn the ignition to the ON position without starting the engine.
Navigate to the EPS section and record any error codes.
Clear the error codes using the scanner’s functions.

4. Confirm EPS System Operation

Start the vehicle and observe if the EPS light remains off.
Test the steering function to ensure it operates smoothly and without noise.
If the EPS light returns, further diagnosis of the EPS system may be required.

5. Final Check

If the EPS light is off and steering is normal, close the hood and perform a test drive to confirm the issue is resolved.