how to reset the check engine light on my Toyota Corolla E170 (2013-2019)

Toyota Corolla E170 (2013-2019)

Error Codes

30 minutes to 1 hour

Time

medium

Difficulty

medium

Severity

2 min read

374 words

Problem Statement

Learn how to reset the check engine light on your 2013-2019 Toyota Corolla E170. Step-by-step guide with diagnostic procedures and tools required.

Affected Component

Engine

Estimated Time

30 minutes to 1 hour

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is off before connecting or disconnecting the battery.
•Exercise caution when working near electrical components.

Symptoms

•Check engine light illuminated
•Engine performance issues
•Poor fuel economy
•Emission test failure

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner to identify the issue causing the check engine light.
2
Resolve the identified issue, if necessary (e.g., repair or replace faulty components).
3
Clear error codes using the OBD-II scanner.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Socket wrench

Parts Required

•Battery

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Ensure the vehicle is parked on a level surface and the ignition is turned off.
Gather all necessary tools including an OBD-II scanner.

2. Connect OBD-II Scanner

Locate the OBD-II port under the dashboard, typically near the driver's side.
Plug the OBD-II scanner into the port.

3. Read and Clear Codes

Turn the ignition to the "ON" position without starting the engine.
Follow the scanner's instructions to read the existing error codes.
Once noted, select the option to clear or reset the codes.

4. Disconnect the Battery (Optional)

If the scanner does not clear the light, disconnect the negative battery terminal using a socket wrench.
Wait for about 15 minutes to reset the vehicle's computer.
Reconnect the negative battery terminal and ensure it is tight.