how to reset the check engine light in a Toyota Corolla E170 (2013-2019)

Toyota Corolla E170 (2013-2019)

Error Codes

15-30 minutes

Time

easy

Difficulty

medium

Severity

2 min read

398 words

Problem Statement

Learn how to reset the check engine light in a 2013-2019 Toyota Corolla E170. Step-by-step guide with diagnostic procedures and instructions.

Affected Component

Engine

Estimated Time

15-30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is stationary and on a flat surface before performing any checks or resets.

Symptoms

•Check engine light illuminated
•Possible error codes stored in the vehicle’s computer
•Engine performance issues (if not addressed)
•No other warning lights illuminated

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner.
2
Address the underlying issue that triggered the check engine light.
3
Clear error codes using the OBD-II scanner.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner

Parts Required

•None for the reset process, but ensure any underlying issues are repaired.

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather necessary tools and equipment.
Ensure that the vehicle is parked on a flat surface and the engine is off.
Have the OBD-II scanner ready.

2. Connect the OBD-II Scanner

Locate the OBD-II port, typically found under the dashboard near the driver's seat.
Plug the OBD-II scanner into the port.
Turn the vehicle's ignition to the "ON" position without starting the engine.

3. Read and Clear Error Codes

Follow the prompts on the OBD-II scanner to read error codes.
Note any error codes that are displayed for future reference.
To clear the codes, select the "Erase Codes" or "Clear Codes" option on the scanner.
Confirm the action when prompted by the scanner.

4. Disconnect the OBD-II Scanner

Once the codes are cleared, disconnect the OBD-II scanner from the port.
Turn off the ignition and remove the key from the ignition switch.

5. Test Drive the Vehicle

Start the engine and check if the check engine light remains off.
Take the vehicle for a short test drive to ensure the light does not come back on.