how to reset the ABS warning light on my Toyota Corolla E170 (2013-2019)

Toyota Corolla E170 (2013-2019)

Error Codes

1-2 hours

Time

medium

Difficulty

medium

Severity

3 min read

498 words

Problem Statement

Learn how to reset the ABS warning light on your 2013-2019 Toyota Corolla E170. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Brakes

Estimated Time

1-2 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems
•Allow the vehicle to cool before inspecting brake components

Symptoms

•ABS warning light illuminated on the dashboard
•Possible intermittent braking performance
•Increased stopping distance
•Potential traction control warning light on
•No audible warning sounds associated with braking

Diagnostic Steps

1
Scan for error codes using OBD-II scanner
2
Inspect ABS components for visible damage or corrosion
3
Check brake fluid level in the reservoir
4
Perform a short test drive to see if the ABS light re-illuminates
5
Clear any stored error codes using the OBD-II scanner

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Basic socket set
•Brake fluid (DOT 3 or DOT 4)

Parts Required

•Replacement ABS sensors (if damaged)
•Brake fluid (if needed)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather necessary tools and parts.
Ensure the vehicle is parked on a level surface and the ignition is turned off.
Disconnect the battery for safety.

2. Check Brake Fluid Level

Locate the brake fluid reservoir, typically found near the driver’s side of the engine bay.
Remove the reservoir cap and check the fluid level; it should be between the "MIN" and "MAX" marks.
If low, top off with the manufacturer-recommended brake fluid (usually DOT 3 or DOT 4).

3. Inspect ABS Sensors and Wiring

Locate the ABS sensors at each wheel hub.
Remove any dirt or debris from the sensors and connectors.
Check for damaged wires or loose connections; repair or replace as necessary.

4. Reset ABS Warning Light

Reconnect the battery after confirming all connections are secure.
Use the OBD-II scanner to access the ABS module.
Select the option to clear the error codes, which should reset the ABS warning light.

5. Test Drive and Monitor

Start the vehicle and take it for a test drive to see if the ABS light remains off.
Monitor the braking performance during the drive to ensure proper functionality.