how to reset the ABS light on my Toyota Corolla E170 (2013-2019)?

Toyota Corolla E170 (2013-2019)

Error Codes

30 minutes to 1 hour

Time

medium

Difficulty

medium

Severity

3 min read

443 words

Problem Statement

Learn how to reset the ABS light on your Toyota Corolla E170 (2013-2019). Step-by-step guide with diagnostic steps, tools required, and safety tips.

Affected Component

Brakes

Estimated Time

30 minutes to 1 hour

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always ensure the vehicle is securely parked before performing any maintenance.
•Disconnect the battery before working on electrical systems to avoid shorts or shocks.

Symptoms

•ABS warning light illuminated on the dashboard
•Possible loss of ABS functionality while braking
•Spongy or non-responsive brake pedal
•Increased stopping distance during braking
•Occasional brake system warning light appearing

Diagnostic Steps

1
Scan the vehicle using an OBD-II scanner to check for any stored ABS fault codes.
2
Inspect the ABS sensors and wiring for any visible damage or disconnection.
3
Verify the brake fluid level and condition, ensuring it is within the recommended range.
4
Check the integrity of the brake system, including brake pads and rotors.
5
Ensure the vehicle’s battery is fully charged and in good condition.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Socket set
•Multimeter

Parts Required

•Brake fluid (if needed)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Scan the vehicle using an OBD-II scanner to check for any stored ABS fault codes.
2
Inspect the ABS sensors and wiring for any visible damage or disconnection.
3
Verify the brake fluid level and condition, ensuring it is within the recommended range.
4
Check the integrity of the brake system, including brake pads and rotors.
5
Ensure the vehicle’s battery is fully charged and in good condition.

Solution

1. Preparation

Tools Required: OBD-II scanner, socket set, multimeter.
Ensure the vehicle is parked on a level surface and the ignition is off.
Disconnect the negative battery terminal to reset the vehicle’s electrical systems.

2. Use OBD-II Scanner

Connect the OBD-II scanner to the vehicle’s diagnostic port.
Turn the ignition to the "ON" position without starting the engine.
Navigate to the ABS section of the scanner and select "Clear Codes" or "Reset ABS Light."
Follow the prompts on the scanner to complete the reset.

3. Reconnect Battery

After clearing the codes, turn off the ignition and disconnect the scanner.
Reconnect the negative battery terminal and ensure it is secure.

4. Test the System

Start the vehicle and check if the ABS light remains off.
Take the vehicle for a short test drive to ensure the ABS system functions correctly and the light does not reappear.