how to replace windshield wipers on my Toyota Corolla E170 (2013-2019)

Toyota Corolla E170 (2013-2019)

Error Codes

30 minutes

Time

easy

Difficulty

low

Severity

3 min read

405 words

Problem Statement

Learn how to replace windshield wipers on your 2013-2019 Toyota Corolla E170. Step-by-step guide with symptoms, diagnostic steps, and installation instructions.

Affected Component

Body/Interior

Estimated Time

30 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is off and the wipers are in the 'off' position before starting the replacement.

Symptoms

•Wipers leave streaks or smears on the windshield
•Wipers make a squeaking or chattering noise during operation
•Wipers do not make full contact with the windshield
•Rubber blade is cracked or torn
•Wipers do not clear the windshield effectively when activated

Diagnostic Steps

1
Inspect the wiper blades for visible signs of wear, cracks, or damage.
2
Activate the wipers to check for proper movement and alignment.
3
Review the owner's manual for specific wiper blade size and type.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Park the vehicle on a level surface and turn off the ignition.
•Ensure the wipers are in the "off" position.

Parts Required

•New windshield wiper blades (specific size for Toyota Corolla E170)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Tools Required: None required for this procedure.
Park the vehicle on a level surface and turn off the ignition.
Ensure the wipers are in the "off" position.

2. Remove Old Wiper Blades

Lift the wiper arm away from the windshield until it is in a vertical position.
Locate the release tab on the wiper blade connector.
Press the release tab while sliding the wiper blade downwards off the wiper arm.
Repeat the process for the other wiper blade.

3. Install New Wiper Blades

Take the new wiper blade and align the connector with the wiper arm.
Slide the blade onto the arm until you hear a click, indicating a secure fit.
Gently lower the wiper arm back against the windshield.
Repeat for the second wiper blade.

4. Final Check

Once both blades are installed, lift the wiper arms again and check that both blades are securely attached.
Lower the wiper arms back onto the windshield and ensure they sit flat.