how to fix the check engine light on a Toyota Corolla E170 (2013-2019)

Toyota Corolla E170 (2013-2019)

Error Codes

1-3 hours

Time

medium

Difficulty

medium

Severity

3 min read

488 words

Problem Statement

Learn how to diagnose and fix the check engine light issue in a 2013-2019 Toyota Corolla E170. Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Engine

Estimated Time

1-3 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Disconnect the battery before working on electrical systems.
•Allow the engine to cool before working on any engine components.

Symptoms

•Check engine light illuminated
•Possible rough idle
•Decreased fuel efficiency
•Engine stalling or misfiring
•Increased emissions
•Unusual noises from the engine

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner to identify specific issues.
2
Check the vehicle’s fluid levels, including oil, coolant, and transmission fluid.
3
Inspect the gas cap for cracks or loose fittings.
4
Examine the air filter for cleanliness and proper installation.
5
Perform a visual inspection of the engine for any signs of leaks or damaged wiring.
6
Test the battery and charging system to ensure proper voltage and function.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•OBD-II scanner
•Socket set
•Oxygen sensor socket
•Screwdrivers

Parts Required

•Oxygen sensor
•Air filter

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Scan for error codes using an OBD-II scanner to identify specific issues.
2
Check the vehicle’s fluid levels, including oil, coolant, and transmission fluid.
3
Inspect the gas cap for cracks or loose fittings.
4
Examine the air filter for cleanliness and proper installation.
5
Perform a visual inspection of the engine for any signs of leaks or damaged wiring.
6
Test the battery and charging system to ensure proper voltage and function.

Solution

1. Preparation

Gather necessary tools and parts.
Disconnect the negative battery terminal to prevent electrical shorts.
Ensure the vehicle is on a flat surface and securely lifted if necessary.

2. Address Error Codes

Reconnect the OBD-II scanner and clear the error codes.
Monitor the vehicle to see if the check engine light reappears after clearing codes.

3. Replace Faulty Components

For example, if the code indicates a faulty oxygen sensor:
- Locate the oxygen sensor (usually on the exhaust manifold or downstream).
- Disconnect the wiring harness from the sensor.
- Remove the sensor using an oxygen sensor socket.
- Install the new sensor, ensuring it is properly seated and tightened to manufacturer specifications (usually around 30 ft-lbs).
- Reconnect the wiring harness.

4. Inspect and Repair Other Issues

If necessary, replace the air filter:
- Remove the air filter housing cover.
- Replace the old air filter with a new one, ensuring it fits snugly.
- Reattach the housing cover securely.

5. Finalize Repairs

Reconnect the negative battery terminal.
Start the vehicle and allow it to reach operating temperature.
Monitor for any unusual sounds or behaviors.