how do I reset the maintenance light on my Toyota Corolla E170 (2013-2019)?

Toyota Corolla E170 (2013-2019)

Error Codes

5 minutes

Time

easy

Difficulty

low

Severity

2 min read

334 words

Problem Statement

Learn how to reset the maintenance light on your 2013-2019 Toyota Corolla E170. Step-by-step guide to ensure your dashboard is clear after maintenance.

Affected Component

Electrical

Estimated Time

5 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in a safe position before performing the reset.

Symptoms

•Maintenance light illuminated on the dashboard
•No error codes present in the system
•The vehicle has recently undergone maintenance

Diagnostic Steps

1
Ensure the vehicle is in the OFF position.
2
Insert the key into the ignition or press the start button without pressing the brake pedal to enter the ON position.
3
Locate the odometer display and ensure it shows the total mileage rather than trip mileage.
4
Turn off the ignition.
5
Press and hold the trip/reset button on the odometer.
6
While holding the button, turn the ignition back to the ON position without starting the engine.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None

Parts Required

•None

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Ensure the vehicle is in the OFF position.
2
Insert the key into the ignition or press the start button without pressing the brake pedal to enter the ON position.
3
Locate the odometer display and ensure it shows the total mileage rather than trip mileage.
4
Turn off the ignition.
5
Press and hold the trip/reset button on the odometer.
6
While holding the button, turn the ignition back to the ON position without starting the engine.

Solution

1. Preparation

Gather necessary tools: None required for this procedure.
Ensure the vehicle is parked in a safe location.
Have the vehicle in a quiet environment for easy access to the dashboard.

2. Reset the Maintenance Light

With the trip/reset button held down, turn the ignition switch to the ON position (do not start the engine).
Continue to hold the trip/reset button for approximately 10 seconds.
The maintenance light will start to blink and then turn off; release the button once the light turns off.
Turn the ignition off and then back on to confirm that the maintenance light has been reset.