why does my Toyota Corolla E140 (2006-2013) make a clicking noise when turning

Toyota Corolla E140 (2006-2013)

Error Codes

4-8 hours

Time

medium

Difficulty

medium

Severity

3 min read

515 words

Problem Statement

Learn how to diagnose and fix clicking noise when turning in Toyota Corolla E140 (2006-2013). Step-by-step guide with diagnostic procedures and repair instructions.

Affected Component

Suspension

Estimated Time

4-8 hours

⚠️ Safety Warnings

Important safety information - read before proceeding

•Always disconnect the battery before working on electrical components.
•Allow the vehicle to cool before performing any work to avoid burns.

Symptoms

•Clicking noise when turning the steering wheel
•Noise occurs during both left and right turns
•Possible vibration felt in the steering wheel
•Increased wear on tires due to misalignment
•No noticeable changes in engine performance

Diagnostic Steps

1
Inspect the CV joints for any signs of damage or wear.
2
Check the wheel bearings for play or roughness.
3
Examine the suspension components, including control arms and bushings.
4
Ensure that the lug nuts are properly torqued.
5
Test the steering rack for any unusual sounds or movement.

Solution

💡 Expert Tip

For complex repairs like this, consider taking photos at each step. This helps if you need to reverse a step or consult with a mechanic. Also, keep all removed parts organized - you may need to reference them during reassembly.

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•Socket set
•Torque wrench
•Jack and jack stands
•Bearing puller

Parts Required

•CV joint assembly (if damaged)
•Wheel bearings (if worn)
•Suspension components (if damaged)

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Solution

1. Preparation

Gather tools and parts required for the repair.
Ensure the vehicle is parked on a level surface and the ignition is off.
Disconnect the battery to avoid any electrical issues.

2. Inspect and Replace CV Joints

Step 1: Lift the vehicle using a jack and secure it with jack stands.
Step 2: Remove the front wheels using a socket set.
Step 3: Inspect the outer CV joint boots for tears or leaks; if damaged, replace the CV joint.
Step 4: To replace the CV joint, remove the axle nut using a torque wrench and pull the axle out of the hub.
Step 5: Install a new CV joint and axle in reverse order, ensuring to torque the axle nut to manufacturer's specifications (typically around 140 ft-lbs).

3. Inspect and Replace Wheel Bearings

Step 1: Once the wheel is removed, check the wheel bearing for play. If excessive play is found, proceed with replacement.
Step 2: Remove the brake caliper and rotor to access the wheel bearing.
Step 3: Use a bearing puller to remove the old bearing and install a new one.
Step 4: Reassemble the brake components and wheels, ensuring everything is tightened to spec.

4. Inspect Suspension Components

Step 1: Visually inspect control arms, bushings, and tie rod ends for wear or damage.
Step 2: Replace any worn components as needed, ensuring proper alignment of the suspension.