how to reset the maintenance light on my Toyota Corolla E140 (2006-2013)

Toyota Corolla E140 (2006-2013)

Error Codes

5-10 minutes

Time

easy

Difficulty

low

Severity

3 min read

441 words

Problem Statement

Learn how to reset the maintenance light on your Toyota Corolla E140 (2006-2013) with this easy step-by-step guide. No tools required.

Affected Component

Electrical

Estimated Time

5-10 minutes

⚠️ Safety Warnings

Important safety information - read before proceeding

•Ensure the vehicle is in 'Park' (for automatic transmissions) or 'Neutral' (for manual transmissions) before performing the reset.

Symptoms

•Maintenance light is illuminated on the dashboard
•Vehicle owner may be prompted for service
•No other performance-related symptoms are present

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position and the key is removed from the ignition.
2
Insert the ignition key and turn it to the 'ON' position without starting the engine.
3
Locate the odometer display and ensure it is set to the trip meter (Trip A).
4
Press and hold the trip meter reset button while turning the ignition key to the 'OFF' position.
5
Continue holding the trip meter reset button and turn the ignition key back to the 'ON' position.
6
Release the trip meter reset button once the maintenance light begins to flash and then turns off.

Solution

Verification

After completing the repair, verify that the issue has been resolved:

✓Test the affected component to ensure it functions correctly
✓Check for any error codes or warning lights
✓Monitor the vehicle for a few days to ensure the issue does not recur

Prevention Tips

To prevent this issue from occurring again:

•Follow the manufacturer's recommended maintenance schedule
•Address warning signs early before they develop into major issues
•Use quality parts and fluids recommended for your vehicle
•Keep detailed records of all repairs and maintenance

Tools & Equipment Required

•None

Parts Required

•None

Related Faults

Share this solution

Comments

No comments yet

Be the first to share your thoughts

Back to Generation

Diagnostic Steps

1
Ensure the vehicle is in the 'OFF' position and the key is removed from the ignition.
2
Insert the ignition key and turn it to the 'ON' position without starting the engine.
3
Locate the odometer display and ensure it is set to the trip meter (Trip A).
4
Press and hold the trip meter reset button while turning the ignition key to the 'OFF' position.
5
Continue holding the trip meter reset button and turn the ignition key back to the 'ON' position.
6
Release the trip meter reset button once the maintenance light begins to flash and then turns off.

Solution

1. Preparation

Gather necessary tools: None required for this task.
Ensure the vehicle is parked on a level surface and the ignition is off.

2. Turn Ignition to "ON"

Insert the key into the ignition.
Turn the key to the "ON" position without starting the engine. The dashboard lights should illuminate, and the maintenance light will be visible.

3. Reset the Trip Meter

Locate the trip meter reset button on the dashboard.
Press and hold the trip meter reset button.

4. Turn Ignition to "OFF"

While holding the trip meter reset button, turn the ignition key back to the "OFF" position.

5. Turn Ignition Back to "ON"

While still holding the trip meter reset button, turn the ignition key back to the "ON" position.
Observe the maintenance light; it should begin to flash and then turn off.

6. Release the Trip Meter Button

Once the maintenance light is off, release the trip meter reset button.